Wolfcraft 6155, 6156 Assemble Push Shoe, Assemble Jointing Fence to Router Table Fence, Au Av

Assemble Push Shoe

AU (1) black

AV (2) black

AW (1) black

1.On one end of the threaded clamp rod (S), thread the clamp plate (T) about 1/2".

2.On same end of rod, add washer (AV) and nut (AU).

3.Slide the clamp rod (S) through push shoe (R) so the end with the clamp plate, washer, and nut is on the large end of the push shoe. See Figure 14.

4.Add washer (AV) and wing nut (AW) to end of threaded rod.

Vibrations from normal WARNING routing may loosen the

washer and bolt that hold the rod to the plate. Occasionally check these components to make sure they are tight.

AU AV	T
	AW
	AV
	S
	R
	Figure 14

Assemble Jointing Fence to Router Table Fence

AX (1) zinc

AH (1) black

1.Using the slots on the fence as guides, slide the jointing fence (W) into the router table fence (V). (Jointing fence may be taped into place at the factory.)

2.Slide hex head bolt (AX) into bottom of jointing fence (W) and through hole in fence (V). Add washer (AH) and jointing fence knob (X). See Figure 15.

3.Slide the jointing fence into the router table fence as far as you can. Remove factory tape if necesssary.

X

AH V

W

AX

Figure 15

19