Wolfcraft 6156, 6155 manual Attach Height-Adjustable Legs

Attach Height-Adjustable Legs

(Model 6155 Only) (continued)

1.Mount four long legs (F) to table using four pan head screws (AJ) and four toothed washers (AP) per leg. Use a #3 Phillips screwdriver to keep from stripping the screw heads. See Figure 7.

2.Use 2 pan head screws (AN), 2 toothed washers (AP), and 2 hex nuts (AQ) to attach a support (C or D) to each long leg (F).

3.Decide what height you want your Router Center table to be from the floor.

4.With the "foot" of short legs (E-1) pointing upward, align 2 holes in short leg with 2 holes in long leg at appropriate height. See Figure 8.

NOTE: Short legs (E-1) mount to the inside of long legs (F).

E-1

AT

AS

AR

F

Figure 8

5.Thread 4 carriage bolts (AR) through the holes in both leg members. Assemble 1 toothed washer (AS) and 1 hex nut (AT) to each bolt.

Tighten nuts.

6.Attach the three remaining legs in the same manner. In order to obtain the same height above the floor, use the same hole positions as the first leg you attached.

7.Attach 4 molded "shoes" (U) to feet. See Figure 9.

8.The table can be leveled by adjusting short legs (E-1) within the slotted mounting holes on the long legs (F).

U

Figure 9

16