Wolfcraft 6156, 6155 manual Using the Fence with Board for Larger Workpieces, Inside Routing

Using the Fence with Board for Larger Workpieces

G

N

P	ULL	ON
		H OFF
PUS		ET
RES

Figure 37

Three holes in the fence allow for mounting of a 8-inch high (maximum) board for safe and secure routing of larger workpieces.

1.Remove push shoe from fence.

2.Attach board to fence with 4 woodscrews (not provided). See Figure 37.

3.Board can be notched out prior to routing or router bit profile can be made in board by driving board through router bit.

4.Position the fence to the desired depth of the cut. Tighten the fence knobs.

5.Securely tighten the router bit, and make sure the router is properly assembled to the router table as previously detailed in this manual.

6.Your router/router table is ready to

rout large workpieces.

Routing Without Push Shoe, Safety Shield, and/or Fence

For many jobs you must remove the fence from the router table.

WARNING Using the router without the safety shield and

fence in place can lead to serious personal injury. Use extreme caution. Operate the router without safety shields and fence ONLY when absolutely necessary, and always with ball-bearing-guided router bits.

Feed workpiece against WARNING the router bit's direction of

rotation. Unplug router prior to changing the bit, modifying settings, or making any other adjustments.

Inside Routing

1.Place your workpiece on the table relative to the router bit as shown in

Figure 38.

		G
		IN
		N
	R
A
W

	ULL	ON
P		H OFF
PUS		ET
RES

OUT LETS

Figure 38

2.Feed your workpiece through the bit in the direction of the arrow. Always

feed against the router bit's direction of rotation.

36