Wolfcraft 6155, 6156 manual Assemble Inserts, Insert Use

Assemble Inserts

Inserts help reduce the amount of wood chips and dust that can accumulate on the router table. They can also lend stability to the work piece.

Four inserts come with your router table. Three of the inserts are for use with a specific size bit; one can be custom drilled. Refer to Figure 31 and to the chart, above right. A center marking is on the back of the blank insert for drilling.

T

U

V

W

Figure 31

	Diameter of
Diameter	Router Bit	Figure 31
of Insert	To Be Used	Reference
1-1/4"	1-1/8"	AA
1-7/8"	1-3/4"	AB
2-1/8"	2"	AC
	drill out no more
1/4 to 2-3/8"	than 2-3/8"	AD
	for 2-1/4" bits

Do not use a router bit WARNING with a diameter of more

than 2-3/4" on this router table.

Insert Use

1.Select correct insert for the router bit and your application.

2.To assemble to router table, press the insert into the hole in the table, applying pressure to all sides equally. This assures that insert snaps into place.

WARNING Before removing insert, switch box must be in

OFF position, router switch must be in OFF position, and power cord must be unplugged from outlet.

3.Remove the insert by placing your finger into the hole in the center. With light pressure, pull up the insert.

NOTE: Remove the router bit from the router before attempting to remove the insert.

31