Attach Short Legs

(Model 6156 Only)

AJ, zinc (16)

AP, black (24)

AN, black (8)

AQ, black (8)

1.Mount four legs (E-1 and E-2) to table using four pan head screws (AJ) and four toothed washers (AP) per leg. Use a #3 Phillips screwdriver to keep from stripping the screw heads.

NOTE: Leg (E-2) is mounted on the front left position of the table top with the safety sticker toward the front of the table. See Figure 10.

 

 

AQ

E-1

 

 

E-1

AP

 

 

E-2

 

AJ

 

 

 

 

 

 

 

 

 

AP

 

 

AW

 

 

 

 

 

AN

 

 

 

R

 

 

 

IN

 

 

 

 

G

N

 

 

 

 

 

 

B-1

 

E-1

 

 

 

 

B-2

Figure 10

2.Use 2 pan head screws (AN), 2 toothed washers (AP), and 2 hex nuts (AQ) to attach a support (C or D) to each leg (E).

Alignment of Tabletop and Extensions

Turn tabletop/extension assembly over and check alignment of extensions and tabletop by sliding miter guide assembly through slot. Loosen screws and adjust alignment of tabletop and extensions if necessary. Retighten screws.

NOTE: Extension (B-2) to be mounted on the right side of the table top. See Figure 11.

SAFETY

STICKERB-2

 

 

 

 

G

 

 

 

IN

 

 

N

 

 

R

 

 

A

 

 

 

W

 

 

 

 

06

5 4

0

3

51

0

51

0 3

5 4

B-1

 

PU

LL ON

 

OFF

 

PUSH

 

 

RESET

OUTL

ETS

 

 

 

G

N

I

N

R

A

W

SAFETY

 

STICKER

Figure 11

 

17

Page 17
Image 17
Wolfcraft 6155, 6156 manual Attach Short Legs, Alignment of Tabletop and Extensions, AJ, zinc AP, black AN, black AQ, black