10 | Appendix A Pin Assignments |
Appendix A Pin Assignments
UTP Port Pin Assignments
The UTP ports use RJ-45 Unshielded Twisted Pair (UTP) cabling. Connector pin numbers and pin wiring assignments are listed below in Figure A-1 and Table A-1, respectively. Twisted-Pair cables can be wired with either straight- through or crossover pin assignments. Both wiring schemes are mentioned in "Appendix B Cabling Guidelines" for reference in creating a twisted-pair cable.
5V 3A
1 2 3 4 5 6 7 8
UTP Port
Each UTP port is configured as “MDI-X”, or internally crossed. By default, all repeating and switched UTP ports are generally configured as MDI-X, unless otherwise specified. The last UTP port (port 5 on the KNS500/WG and port 8 on the KNS800/WG) is linked to a cascade switch that allows it to support UTP cabling in the straight-through (MDI) and crossover (MDI-X) wiring configuration. See page 7 “Notes on MDI and MDI-X” for details.
Fig. A-1 RJ-45 Connector Pin Numbers
Pin Number | MDI-X | MDI |
1 | Receive Data + | Transmit Data + |
| | |
2 | Receive Data - | Transmit Data - |
| | |
3 | Transmit Data + | Receive Data + |
| | |
4,5 | Not Used | Not Used |
| | |
6 | Transmit Data - | Receive Data - |
| | |
7,8 | Not Used | Not Used |
| | |
Table A-1 UTP Pin Assignments
Kingston Technology Company | KNS800/WG User’s Guide – Rev.B01 |