Kingston Technology KND810TX, KND2410TX manual Stack-In / Stack-Out Ports, Stacking Configuration

Page 13

Rear Panel

7

Stack-In / Stack-Out Ports

U S E O N L Y W I T H A 2 5 0 V F U S E

U S E O N L Y W I T H A 2 5 0 V F U S E

U S E O N L Y W I T H A 2 5 0 V F U S E

Fig. 1-4 Stacking Configuration

The Fast EtheRx stackable hubs use stacking ports located on the back of the unit to stack up to a maximum of four hubs, using any combination of the KND810TX, KND1610TX, and KND2410TX models. Follow the directions below on stacking these hubs together:

1.Power down the Fast EtheRx hub(s).

2.Locate the 50-pin shielded stacking cable included with your package contents.

3.Plug one end of the cable into the port labeled, “Stack-Out”on the first hub.

4.Plug the other end of the cable into the “Stack-In”port on the second hub.

5.Repeat steps 2 through 4 for stacking up to a maximum of four (4) hubs.

Kingston’s Stack-n-Play™feature offers greater scalabilty to add UTP ports without the need to configure ID or termination switches. When configured as a stack, the Fast EtheRx stackable hubs are recognized as a single unit on the network. By stacking hubs together, you can expand the total number of UTP ports up to 96 ports.

KND2410TX User’s Guide - Rev. A01

Kingston Technology Company

Image 13

Contents Models KND810TX KND1610TX KND2410TX Page 10/100TX Rack-Mountable Dual Speed Hubs User’s Guide Important Safety InstructionsPart No -001.A01 Table Of Contents Power Switch AC Power Connector Kingston Technology Company KND2410TX User’s Guide Rev. A01 Model Types IntroductionPackage Contents Special FeaturesDesign Features Front Panel Hardware InstallationUplink Port 10/100TX UTP PortsAC Power Connector Power SwitchRear Panel FuseStack-In / Stack-Out Ports Stacking ConfigurationPort no or Speed-Setting Dip SwitchesAppendices UTP Port Pin Assignments Appendix a Pin AssignmentsUTP Cable Wiring Standards UTP Cable WiringAppendix B Cabling Guidelines UTP Cable TypeT568A Pairs Strand Solid UTP Cable Rating CodesTerms You Should Be Familiar With Appendix C SpecificationsAppendix C Specifications Class I vs. Class II 100BASE-TX Fast Ethernet Repeaters Appendix D Commonly Asked QuestionsCategory 5 Compliance vs. Category 5 Performance? Appendix E Warranties and NoticesDuration of Warranty Limited Warranty StatementFree Technical Support Warranty Claim RequirementsDisclaimers CE Notice C. CertificationTick Certification