Kingston Technology KNS1650/R, KNS3250/R, KNS2450/R manual Load Balancing Mapping Port Based

Page 23

18	Kingston Switch Configuration Utility

Load Balancing Mapping – Port Based

The port-based load balancing method is an explicit port assignment scheme. It requires that all other ports are assigned to a specic link (trunk port) in the trunk. When the switch receives a packet with a trunk destination, it will automatically forward the packet to a trunk port based on the port it came from.

First select a trunk, then click its Port Based button on the right hand side of the screen under Load Balancing Mapping. The Port Based Trunk Port Mapping for Trunk x window will appear as shown below.

Click the radio buttons to map each port to one of the trunk ports. All assignments must be completed before it will allow you to close the window. After that, the status will display ‘ok’ on the right side of the Port Based button. If the status ‘not yet’ is displayed, then the load-balancing mapping has not been completed.

Kingston Technology Company

KNS3250/R User’s Guide - Rev. A00

Image 23

Contents Models KNS1650/R KNS2450/R KNS3250/R KNS3250/R Users Guide Rev. A00 Wichtige Sicherheitshinweise Important Safety InstructionsTable of Contents Kingston Technology Company Introduction Model Types Special FeaturesPackage Contents Auto-Negotiation Design FeaturesSwitching Function Link TrunkingFlow Control Store-and-Forward SwitchingFull-Duplex Link / Activity LED Hardware InstallationPower LED 10/100TX UTP Ports AC Power ConnectorFull Duplex and Collision LED Fiber FX module port optionalFile Software InstallationSwitch Conguration Utility Device Conguration Main ScreenPrinter Port I/O Address Device TypeKingston Switch Configuration Utility Aging Control Device Conguration PropertiesSystem SuperMACDescription Aging TimeBroadcast Storm Control Threshold Security PortPort Selection Full Duplex Flow Control Duplex ModeAddress Learning Broadcast Storm ControlTrunk Assignment Load Balancing Mapping MAC Address Based Load Balancing MethodTrunk Selection, Trunk Port Assignment Last byte of source MAC address SA Load Balancing Mapping Port Based Flood Control VlanVlan Group Kingston Switch Configuration Utility Explicit Address Table Explicit Address TableKingston Switch Configuration Utility Editing a Conguration File Using the Switch Conguration UtilitySending the Current Conguration to the Switch Kingston Technology Company Vlan #1 Engineering Assigning Trunks and Setting Vlan GroupsKingston Technology Company Kingston Switch Configuration Utility Kingston Technology Company Kingston Switch Configuration Utility Kingston Technology Company Data cannot be read from or written to the device TroubleshootingKingston Technology Company Appendices UTP Port Pin Assignments Appendix a Pin AssignmentsUTP Cable Type UTP Cable WiringAppendix B Cabling Guidelines Table B-4 4-Pair T568A Wiring UTP Cable Wiring StandardsTerms You Should Be Familiar With UTP Cable Rating CodesAppendix C Specications Environmental KNS150FX/SC Appendix D Fiber FX Modules & InstallationInstalling the ber module Brackets for Rack Mounting Appendix E Mounting TemplatesRubber Feet for Desktops Appendix F Warranties and Notices Limited Warranty StatementDuration of Warranty Disclaimers Warranty Claim RequirementsFree Technical Support Tick Certication C. CerticationCE Notice