Kingston Technology KNS2450/R, KNS3250/R, KNS1650/R C. Certication, CE Notice, Tick Certication

Page 52

Appendix F - Warranties & Notices

47

F.C.C. Certication

This device has been tested and found to comply with limits for Class A digital device, pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)This device must accept any interference received; including interference that may cause undesired operation.

CE Notice

The ofcial CE symbol indicates compliance of this Kingston Technology product to the EMC directive of the European Community. The CE symbol indicates that this Kingston product meets or exceeds the following standards:

qEN50081-1“Electromagnetic Compatibility-generic emissions standard”

EN55022: “Limits and methods of measurement of radio interference characteristics.”

qEN50082-1“Electromagnetic Compatibility-generic immunity standard”

IEC 801-2: “Electrostatic discharge requirements”

IEC 801-3: “Radiated immunity requirements”

IEC 801-4: “Electrical fast transient requirements”

qEN60950 “Low Voltage Directive (LVD)”

qDeclaration of CE Conformity in accordance with the above standards has been made and is on le at Kingston Technology.

C-Tick Certication

q AS/NZS 3548 “Information Technology Equipment”

q Declaration of C-Tick Conformity in accordance with the above standards has been made and is on le at Kingston Technology.

N1298

KNS3250/R Users Guide - Rev. A00

Kingston Technology Company

Image 52
Contents Models KNS1650/R KNS2450/R KNS3250/R KNS3250/R Users Guide Rev. A00 Important Safety Instructions Wichtige SicherheitshinweiseTable of Contents Kingston Technology Company Introduction Special Features Model TypesPackage Contents Design Features Switching FunctionLink Trunking Auto-NegotiationFull-Duplex Store-and-Forward SwitchingFlow Control Power LED Hardware InstallationLink / Activity LED AC Power Connector Full Duplex and Collision LEDFiber FX module port optional 10/100TX UTP PortsSoftware Installation Switch Conguration UtilityDevice Conguration Main Screen FileDevice Type Printer Port I/O AddressKingston Switch Configuration Utility Device Conguration Properties SystemSuperMAC Aging ControlBroadcast Storm Control Threshold Aging TimeDescription Port Selection PortSecurity Duplex Mode Address LearningBroadcast Storm Control Full Duplex Flow ControlTrunk Assignment Trunk Selection, Trunk Port Assignment Load Balancing MethodLoad Balancing Mapping MAC Address Based Last byte of source MAC address SA Load Balancing Mapping Port Based Vlan Flood ControlVlan Group Kingston Switch Configuration Utility Explicit Address Table Explicit Address TableKingston Switch Configuration Utility Using the Switch Conguration Utility Editing a Conguration FileSending the Current Conguration to the Switch Kingston Technology Company Assigning Trunks and Setting Vlan Groups Vlan #1 EngineeringKingston Technology Company Kingston Switch Configuration Utility Kingston Technology Company Kingston Switch Configuration Utility Kingston Technology Company Troubleshooting Data cannot be read from or written to the deviceKingston Technology Company Appendices Appendix a Pin Assignments UTP Port Pin AssignmentsAppendix B Cabling Guidelines UTP Cable WiringUTP Cable Type UTP Cable Wiring Standards Table B-4 4-Pair T568A WiringUTP Cable Rating Codes Terms You Should Be Familiar WithAppendix C Specications Environmental Appendix D Fiber FX Modules & Installation KNS150FX/SCInstalling the ber module Rubber Feet for Desktops Appendix E Mounting TemplatesBrackets for Rack Mounting Duration of Warranty Limited Warranty StatementAppendix F Warranties and Notices Free Technical Support Warranty Claim RequirementsDisclaimers CE Notice C. CerticationTick Certication