Juniper Networks manual Connecting the NETSCREEN-200 Device to Other Devices

Connecting the NetScreen-200 Device to Other Devices

CONNECTING THE NETSCREEN-200 DEVICE TO OTHER DEVICES

To connect the device, use the ethernet interfaces (ethernet1 through ethernet4 on the NetScreen-204, or ethernet1 through ethernet8 on the NetScreen-208). The purpose of each interface depends upon the security zone to which it is bound.

By default, the zone and interface bindings are as follows:

•ethernet1 is bound to the Trust security zone by default.

Connect this interface using a twisted pair cable with RJ-45 connectors.

•ethernet2 is bound to the DMZ security zone by default.

Connect this interface using a twisted pair cable with RJ-45 connectors.

•ethernet3 is bound to the Untrust security zone by default.

Connect this interface using a twisted pair cable with RJ-45 connectors.

•ethernet4 through ethernet8: Can be connected as required.

The default IP address of each ethernet interface is 0.0.0.0/0.

For information on interfaces and security zones, see “The NetScreen-200 Series Device Interfaces” on page 17.

NetScreen-200 Series 13