Juniper Networks manual NetScreen-204 Device, NetScreen-208 Device, NETSCREEN-200 Systems

Page 8

Chapter 1 Overview

NETSCREEN-200 SYSTEMS

This NetScreen-200 Series currently includes the NetScreen-204 device and the NetScreen-208 device.

NetScreen-204 Device

The NetScreen-204 is a chassis-based, rack-mountable network security device with four ethernet 10/100 Base-T interface ports. The figure below shows a NetScreen-204 device.

System Status LEDs Asset Recovery							Ethernet Interfaces
	Console		Modem		Compact Flash
Pinhole	Port		Port		Card Slot

NetScreen-208 Device

The NetScreen-208 is a chassis-based, rack-mountable network security device with eight ethernet 10/100 Base-T interface ports. The figure below shows a NetScreen-208 device.

System Status LEDs Asset Recovery	Console	Modem	Compact Flash	Ethernet Interfaces
Pinhole	Port	Port	Card Slot

2	User’s Guide

Image 8

Contents NETSCREEN-200 Series Copyright Notice Contents IX-I Preface Guide OrganizationCommand Line Interface CLI Conventions Juniper Networks Netscreen PublicationsOverview1 NETSCREEN-200 Systems NetScreen-204 DeviceNetScreen-208 Device System Status LED Display Front PanelAsset Recovery Pinhole RedConsole and Modem Ports Compact Flash Card SlotRear Panel Power SuppliesEthernet Interfaces Power Fuse Overview User’s Guide Installing the Device Performing EQUIPMENT-RACK Installation Equipment Rack Installation GuidelinesGeneral Installation Guidelines Mid-Mount Connecting the PowerFront Mount Wiring a DC Power Supply Connecting the NETSCREEN-200 Device to Other Devices Installing the Device User’s Guide Configuring the Device Operational Modes Transparent ModeRoute Mode NETSCREEN-200 Series Device Interfaces Ethernet1 through ethernet8Connecting the Device AS a Single Security Gateway Connectivity ExamplesPerforming Device Connection Establishing AN HA Connection Between Devices DeviceDevice Performing Initial Connection and Configuration Establishing a Terminal Emulator ConnectionChanging Your Admin Name and Password Setting Port and Interface IP AddressesSetting the IP Address of the Management Interface Starting a Console Session Using Telnet Configuring the Device for Telnet and Webui SessionsStarting a Console Session Using Dialup Establishing a GUI Management SessionNetScreen WebUI application window appears Using CLI Commands to Reset the Device Asset RecoveryUsing the Asset Recovery Pinhole to Reset the Device Configuring the Device User’s Guide Specifications Electrical Specification Safety CertificationsNETSCREEN-200 Attributes EnvironmentalIndex IX-II