Juniper Networks manual NETSCREEN-200 Attributes, Electrical Specification, Environmental

Page 38

Appendix A Specifications

NETSCREEN-200 ATTRIBUTES

Height:1.73 inches (4.4 cm)

Depth:10.8 inches (27.4 cm)

Width:17.5 inches (44.5 cm)

Weight: 8 pounds (36 hg)

ELECTRICAL SPECIFICATION

AC voltage:100-240 VAC +/- 10%

DC voltage:-36 to -60 VDC

AC Watts:45 Watts

DC Watts:50 Watts

Fuse Rating:2.5Amps / 250Volts

ENVIRONMENTAL

Temperature	Operating	Non-operating

Normal altitude	0°-50°C, 32-122°F	-40°-158°F, -40°−70°C

Relative humidity	10-90%	5-95%

Non-condensing	10-90%	5-95%

The maximum normal altitude is 0 - 12,000 ft. (0 - 3,660 m)

NEBS CERTIFICATIONS

Level 3 (NetScreen-208 with DC power) GR-63-Core:NEBS, Environmental Testing

GR-1089-Core:EMC and Electrical Safety for Network Telecommunications Equipment

SAFETY CERTIFICATIONS

UL, CUL, CSA, CB, Austel, CE

EMI CERTIFICATIONS

FCC class A, BSMI, CE class A, C-Tick, VCCI class A

A-II	User’s Guide

Image 38

Contents NETSCREEN-200 Series Copyright Notice Contents IX-I Preface Guide OrganizationCommand Line Interface CLI Conventions Juniper Networks Netscreen PublicationsOverview1 NETSCREEN-200 Systems NetScreen-204 DeviceNetScreen-208 Device System Status LED Display Front PanelAsset Recovery Pinhole RedConsole and Modem Ports Compact Flash Card SlotRear Panel Power SuppliesEthernet Interfaces Power Fuse Overview User’s Guide Installing the Device Performing EQUIPMENT-RACK Installation Equipment Rack Installation GuidelinesGeneral Installation Guidelines Mid-Mount Connecting the PowerFront Mount Wiring a DC Power Supply Connecting the NETSCREEN-200 Device to Other Devices Installing the Device User’s Guide Configuring the Device Operational Modes Transparent ModeRoute Mode NETSCREEN-200 Series Device Interfaces Ethernet1 through ethernet8Connecting the Device AS a Single Security Gateway Connectivity ExamplesPerforming Device Connection Establishing AN HA Connection Between Devices DeviceDevice Performing Initial Connection and Configuration Establishing a Terminal Emulator ConnectionChanging Your Admin Name and Password Setting Port and Interface IP AddressesSetting the IP Address of the Management Interface Starting a Console Session Using Telnet Configuring the Device for Telnet and Webui SessionsStarting a Console Session Using Dialup Establishing a GUI Management SessionNetScreen WebUI application window appears Using CLI Commands to Reset the Device Asset RecoveryUsing the Asset Recovery Pinhole to Reset the Device Configuring the Device User’s Guide Specifications NETSCREEN-200 Attributes Electrical SpecificationSafety Certifications EnvironmentalIndex IX-II