operation is also straightforward and is discussed in Section 4.0.
Should problems develop during installation or operation, this section is intended to help locate, identify and correct these types of problems. Please follow the suggestions listed below prior to contacting your supplier. However, if you are unsure of the procedures described in this section, or if the Magnum 200X product is not performing as expected, do not attempt to repair the unit; instead contact your supplier for assistance or contact Garrett Communications Customer Support.
5.1Before Calling for Assistance
1.If difficulty is encountered when installing or operating the unit, refer back to the Installation Section of this manual. Also check to make sure that the various components of the network are
2.Check the cables and connectors to ensure that they have been properly connected and the cables/wires have not been crimped or in some way impaired during installation. (About 90% of network downtime can be attributed to wiring and connector problems.)
3.Make sure that the power cord is properly attached to each unit. Be certain that the AC power cord is plugged into a functioning electrical outlet. Use the PWR LEDs to verify the unit is receiving proper power.
4.If the problem is isolated to a network device other than the Magnum
200X product, it is recommended that the problem device is replaced with a known good device. Verify whether or not the problem is corrected.
5.If the problem continues after completing Step 4, above, contact your supplier from whom you purchased the product for assistance, or Garrett Communications
Customer Support.