GarrettCom Magnum 500-Series chassis, 2a Front view Magnum 508, 528 and 528F Switching Hubs

Magnum 500-Series Switching Hubs Installation and User Guide (08/98)

Designed for use in departments with multiple workgroups, in remote offices and in network traffic centers, the Magnum 500-Series switches are easy to install and use. Addresses of attached nodes are automatically learned and maintained, adapting the switching services to network changes and expansions. The Magnum 500s provide high performance plug-and-play operation in a compact package.

2.2.1Magnum 500-Series chassis

	Magnum 500-series
	Switching Hub
GARRETT
PWR	10Mb
LK /RX		FDX

							UPLINK
1	2	3	4	5	6	7	8

			Magnum 500-series
			Switching Hub
	GA RRETT
PWR		AUTO	10M b
L K RX	100 Mb	L IN K	RX

TX RX

100	LK							UPL INK
10	RX
F/H	F/H
	1	2	3	4	5	6	7	8

			Magnum 500-series
			Switching Hub
	GARRETT
PWR		AUTO	10Mb
LK /RX	FDX	LK /RX		FDX

	100		100								UPLINK
	10		10
F/H	1	2	F/H	1	2	3	4	5	6	7	8

			Magnum 500-series
			Switching Hub
	GARRETT
		AUTO	10Mb
L K RX	100 Mb	LINK	RX
TX	RX

				LK							UPLINK
F	H	F	H
				RX
				F/H
				1	2	3	4	5	6	7	8

Figure 2.2a: Front view Magnum 508, 528 and 528F Switching Hubs

Magnum 500-Series switching hubs are equipped with eight shielded RJ-45 ports for shielded and unshielded 10BASE-T connections. Magnum 528 switching hubs also have two shielded RJ-45 Fast Ethernet ports for 100BASE-TX connection. Both units include a up-link switch for crossover connection located next to 10Mb Port # 8. Each 10Mb RJ-45 connector has two LED’s, one to indicate LK/RX (LINK / Receive) activity and the other (FDX) for indicating full-duplex mode.

On Magnum 528 and 528F models, the 100Mb activity LEDs and the LINK LEDs are located in the copper Fast Ethernet ports. Other LEDs indicate when auto- negotiation (copper only) is internally selected, that operating speed is 10Mb or 100Mb, and when the operating mode is full-duplex. Magnum 528 and 528F models also have two full/half (F/H) switches for the two 100Mb ports for manual selection of the full- or half-duplex mode when auto-negotiation is not selected. All connectors, switches and LED’s are located on the front panel, with the AC power connector located at the rear.

Figure 2.2b: Rear view

--Magnum 508, 528 and 528F Switching Hub

GARRETT

GARRETT

115-230V~ 50/60 Hz

5