GarrettCom 500-Series manual Wall or Vertical Surface Mounting

Page 20

Magnum 500-Series Switching Hubs

Installation and User Guide (08/98)

 

 

3.1.2Wall (or Vertical Surface) Mounting

Each Magnum 500-Series switch is shipped with two metal mounting brackets (and screws) to allow the unit to be mounted in nearly any desired orientation or position. The brackets are attached to the metal hub case using one of the metal screws for each bracket, and attached to the Magnum 500 through the round hole of the bracket. A user- supplied screw attaches the bracket to the mounting surface. It is recommended that the mounting brackets be attached to two opposite corners of the unit. When properly attached, the brackets will extend slightly below the base of the unit to allow clearance for the rubber feet and for cooling fan exhaust space.

Magnum 500-series

Switching Hub

GARRETT

GARRETT

 

PW

 

R

LK/RX

Proper mounting

Magnum 500 with attachedbracket attachment mounting brackets

Figure 3.1: Magnum 500-Series, metal mounting brackets

3.1.3Optional E-Stand

The optional E-Stand provides a vertical mounting option for the Magnum 500-Series Hubs. When horizontal placement is not possible or desirable (such as on the floor in carpeted areas), the E-Stand offers a unique space management option. Simply align the rectangular cut-out on the E-Stand with the air vent on either side of the Magnum 500 unit.

The E-Stand also allows the Magnum 500-Series unit to be securely mounted via two screws that connect through the E-Stand and into the side of the unit.

See Figure 3.1.3, following.

GARRETT

15

Page 19 Page 21
Image 20
Page 19 Page 21
Contents Switching Hubs Trademarks Contacting Garrett Communications Fax 510 Email support@garrettcom.comInstallation Table of ContentsMagnum Specifications Power Supply Internal Warranty100Mb/s Multi-mode Port Optical Typical Worst LEDsOrdering Information MagnumMagnum 528F-SC Magnum 528F-STInspecting the Package and Product Product Description Magnum 500-Series Switching HubsIntroduction 2a Front view Magnum 508, 528 and 528F Switching Hubs Magnum 500-Series chassisUplink @ 100Mb Fiber port, type ST or SC Magnum 528F models only Frame Buffering and LatencyGarrett Full-duplex or Half-duplex operation, auto-sensing High PerformanceAssured 100Mb performance in any network set-up Dynamic Buffer Space AllocationApplications Example 1 MagnumExample 2 Magnum Example 3 Magnum InternetExample 4 Magnum 528F InternetInstallation Locating Magnum 500-Series switchesWall or Vertical Surface Mounting Magnum 500-Series, metal mounting brackets Optional E-StandMagnum 500-Series AC power connector 100BASE-TX connections Magnum 528 only Connecting Ethernet MediaMedia Ieee Standard Connecting Fiber Optic 100BASE-FX, Type ST and SC 100BASE-TX connections Magnum 528F onlyMagnum 528’s internal jumpers for auto-negotiation on or OFF OperationAddress Learning Switching FunctionalityFiltering and Forwarding PWR LK/RXFDX AutoAuto-negotiation option for Fast Ethernet copper ports Auto-negotiation for 10Mb ports, half- or full-duplex mode Collision-based Flow-control Troubleshooting Before Calling for AssistanceNo Problem Found When Calling for AssistanceReturn Material Authorization RMA Procedure Shipping and Packaging Information B3.0 Applications Appendix B 48VDC AddendumB2.0 Magnum 508, 528 and 528F 48VDC Option B5.0 Operation B4.0 InstallationB6.0 Troubleshooting
Top Page Image Contents