Fiber Ports # 1, Mechanical, LED Indicators

Magnum P62-Series Hardened Switches

Installation and User Guide (08/03)

Conformal coating (tropical humidity protection) optional, request quote

Power Supply (Internal) 24VDC and -48VDC Power Supply

Power Input Voltage: 20 to 60 VDC (auto-ranging), “-, GND, +”

Power Consumption: 10 watts typical.

DC-DC Converter Rating: 5VDC, 2Amps

Power Supply (Ext.) 125VDC & 250VDC, (PSX-T) for P62-Series -5V only Power Input Voltage: 100 to 275 VDC (nominal rating of 125, 250VDC) Power Consumption: 15 watts typical.

DC-DC Converter Rating: 5VDC, 3Amps

Power Supply (External) AC Power Supply (PSX-A) for P62F-5V and mP62-5V AC Power Connector: IEC-type, male recessed at rear of Power Supply chassis Input Voltage: 85 to 264 VAC (auto-ranging)

Input Frequency: 47 to 63 Hz (auto-ranging)

Power Consumption: 15 watts typical

Power Supply Rating: 3Amps at 5VDC

Network Cable Connectors -6 RJ-45 shielded female ports and 2 fiber port

100Mbps: Category 5 UTP/STP, fiber (50/125, 62.5/125 mm, or single-mode at 9/125 micron)

10 Mbps: Category 3, 4, 5 UTP (Note: auto-sensing does not sense cable type)

Full-duplex / Half -duplex on copper (RJ-45) switched Ports # 2 to 7

All the RJ-45 ports support Full / Half duplex and 10/100 speed, each inde- pendently auto-negotiating on P62F models; S/W controlled on mP62 models.

Fiber Ports # 1 and 8

The switched fiber ports # 1 & 8 are fixed at full-duplex only, 100Mb speed.

Mechanical

Enclosure: Rugged 18-gauge high-strength steel case. Metal mounting plate included. Suitable for stand-alone, shelf, pedestal or wall mounting. The case also serves as a heat sink. The metal mounting base is included, 13-guage steel. (Without the base, the box size is only 7” high). Mounting holes in the base plate are a rectangle that measures 3.35” x 7.92” (8.5 x 20.1 cm) center to center.

See Section 3.1.2 for additional mounting details. Dimensions (wall mounted): 1.70 in D x 5.75 in W x 8.8 in H

(4.3 cm x 14.6 cm x 22.4 cm)

Weight: 3.5 lb. (1.6 kg.)

Cooling method: Convection, with case operating as a heat sink.

Note: Internal thermal materials and techniques (patent pending) conduct heat from the electronic elements inside to the steel case which acts as a heat sink. Internal chip temperatures are only about 10°C above case ambient at steady state operation

LED Indicators

PWR: Steady ON when power applied

SPEED: (when LINK is ON): ON = 100Mbps; OFF = 10 Mbps

LINK/ACT: Steady ON for LINK with no traffic, blinking indicates port is transmitting / receiving.

F/H (RJ-45 ports only): ON = full-duplex, OFF = half-duplex

www . GarrettCom . com