GarrettCom 4K-Series manual Powering the Magnum 4K8 Switch, 3b Removing a FPM Card

Magnum 4K8 Switches Installation and User Guide (10/04)

MAGNUM 4K-Series Ethernet 10/100 Switch

POWER	1	2	3	4	5	6	7	8
	SPEED

ERROR L/A

UPLINK F/H

=	X
F	H
	F	H

A L

H F

Bottom Retainimg Screws for holding FPM Cards

Figure 3.4.3a: Front View - Face Plate & FPM Retaining Screws Step 3. Remove FPM Card

Gently pull the FPM card up and out of the connector socket (see Figure 3.4.3b).

FPM CARD

MAGNUM 4K-Series	POWER		1	2	3	4	5	6	7	8
			SPEED
Ethernet 10/100 Switch	ERROR		L/A
	UPLINK		F/H
	=	X
	F		H
										F	H

Figure 3.4.3b: Removing a FPM Card

If the slot from which the FPM card has been removed is to remain unused, be sure to install a FPM-BLNK face plate cover in it. If another FPM card is replacing the one that has been removed, follow the steps as described for installing a FPM card discussed in Section 3.4.1.

3.5Powering the Magnum 4K8 Switch

The Magnum 4K-Series Switches incorporate an internal universal power supply, and has a

110-220	ON
VAC

47-63Hz

1.0-0.5A OFF

Figure 3.5: Magnum 4K8 AC power connector

recessed male IEC connector for the AC power cord at the left-rear. A manual power ON-OFF switch is adjacent. A six-foot 115 VAC 60 Hz standard power cord is supplied with each unit shipped within the United States and Canada.

www . GarrettCom . com

22