GE PBe manual Programming, HyperTerminal configuration

12

ProBridge Ethernet User Manual

Programming

After you install the PBe, you need to program the ProBridge for operation. This is accomplished by using HyperTerminal or manually setting the DIP switches.

HyperTerminal configuration

You will need the following equipment to program the PBe using HyperTerminal:

•A PC or laptop computer with a COM port and Windows 98/NT/200/XP installed and operational.

•The supplied 4310-0061A PB3 to PC (DB9F to DB9F) cable.

To program the PBe with HyperTerminal, do the following:

1.Remove power and disconnect the PBe from the DVR.

2.Plug the 4310-0061A cable into Port 2 of the PBe and a free COM port on your PC, typically COM1.

3.Launch HyperTerminal, found in Start\Programs\Accessories\Communications\ HyperTerminal.