5 |
System Startup for Windows 2000 Units
Connecting a PS/2 keyboard and Mouse is recommended before you get started. You need a PS/2 keyboard for convenience. The soft keyboard and touch panel will not work until the Windows 2000 operating system is licensed. Therefore an external keyboard is required to license the product.
1. Plug in the keyboard, PS/2 mouse (if available), and power cord.
2. Power on the unit.
3. Read the license agreement.
4. Select your choice and press NEXT >.
5. Choose your regional settings (US default) and press NEXT >.
6. Type your name.
7. Press the TAB key and type your company name.
8. Press NEXT >.
9. Enter your Windows 2000 Product Key found on the back of the Intelligence Panel. When correct, press NEXT >.
Note: Computer names must be less than or equal to ten characters to run CIMPLICITY HMI software. Each computer on a network must have a unique name.
10.Enter a Computer name. This name must be different from other computer names on the same network. Press Next >.
11.If desired, enter an Administrator password. You will need to enter it twice to confirm. When done, press Next >.
12.You can now set the Date, Time and Time Zone for the computer. When the information is correct, press Next >.
13.Choose Typical settings for the factory setting of TCP/IP protocol at IP 111.111.111.111 and subnet 255.0.0.0, or, choose Custom and press Next > to change these settings. Consult your network Administrator for your network’s configuration settings.
14.Choose whether this computer will be on a workgroup or domain and enter the name and press Next >.
15.After completing the network setup, the system will finalize its setup.
At the end of the setup process, you will be asked to reboot the system. Press Finish.
After restarting, you will need to configure the login settings for Windows 2000. When the “Network Identification Wizard” dialog box appears press Next >.
The “Users of This Computer” dialog box appears.
•If you wish to have the computer automatically log on with the administrator account, select the “User name” pull down and choose “Administrator.” Enter the password used in step 11 and press NEXT >. The computer will automatically log on when it starts up.
•If you wish to require a logon when the computer is restarted, select “Users must enter a user name and password to use this computer” and press NEXT >. You will then be asked for a user name and password when the computer starts up.
16.Press Finish and the setup is complete.
Chapter 5 System Operation |