Appliance Installation
CAUTION:
Vent unit to outside of building, only.
The hood can be mounted on a wall or suspended from a cabinet. Both vertical and horizontal discharge are possible with either mounting method.
Discharge Direction: The hood is shipped ready for vertical discharge. To change to horizontal discharge move the discharge cover shown in Figure 1a to the top of the hood. The plate is held in place by 4 (four) screws.
Assembly of the Transition: The supplied transition mounts to the top or rear of the hood depending on the discharge direction.
1.Align mounting holes at base of transition with mounting holes on 1/2” flange located at the top or rear of the hood depending on direction of discharge.
2.Fasten transition to hood using two (2) # 8 sheetmetal screws (included with hood).
3.Seal connection between transition and hood with duct tape.
4.Remove tape holding damper closed.
See Figure 1b for overall hood dimensions.
This opening is covered for horizontal discharge
This opening is covered for vertical discharge.
Figure 1a: Discharge Direction
30", 36", 42", 48", 54" *
18"
27"
Figure 1b: Overall Dimensions | * Varies by model. |
4