12.Before hanging hood, install transition per Figure 6. Fasten transition with two (2) screws (#8 x 3/8 sheet metal, supplied) and tape per all applicable codes.
Note: Screws must not hinder damper operation.
13.Rest the hood on the screws in the wood bracket. Use the keyholes labeled "I" in Figure 8. Make sure the wood bracket fits into the recess on the back of the hood.
14.Remove knockouts.
15.Tighten the screws in keyholes. Check hood for level and adjust if necessary.
16.From inside the hood drive screws (#8 x 5/8”) through holes in hood into wooden bracket. See holes labeled J in Figure 8.
17.Connect additional ducting.
| J |
I | I |
Figure 8
Installation Note: If wall studs are within 8" of the center line, cut stud at an angle to avoid any interference.
Assembly and Installation of the Duct Covers
Optional duct covers shown in Figure 9 may be used to fill the space between the hood and ceiling in wall mount installations. 6" and 12" high duct covers are available and may be ordered separately.
1.If multiple duct covers are used, connect the pieces together using sheetmetal screws provided with duct covers.
2.Attach the duct cover(s) to the hood using sheetmetal screws as shown in Figure 9.
3.From inside of hood, insert screws supplied (#8 x 5/8") through holes L, one (1) on each side and four (4) along the front, into bottom of the cabinet.
L
L
#8 x 3/8” Screw (numbers depend on hood size)
L
Figure 9
7
