Cabinet Installation
The hood can be installed under a cabinet by supporting the hood from the top.
Note: The cabinet must be structurally joined to the wall studs to support the weight of this hood.
Figure 10 shows the four (4) screw holes (K) used for mounting the hood to the bottom of the cabinet.
Make sure both knockouts have been removed.
1. In the base of the cabinet drill |
1/8" tap holes (See Dimension |
A in Figure 10 and in Table). |
Screw in four #10 x 1" screws |
(provided with hood) leaving 1/4" |
exposed). |
{ "
K
L
L
A: Tap Hole Locations
23"
L
K
Note: This figure depicts tap hole and screw hole locations only. See Figure1b, Page 4 for overall hood dimensions.
2. | If the hood is installed for |
| vertical discharge, use Figure 11 |
| to create clearance holes for |
| passage of the transition and |
| conduit (See Dimension B in |
| Figure 11 and in Table). |
3. | For horizontal discharge use |
| Figure 5 for the geometry of the |
| cutout required for clearance of |
| the transition. |
4. | Hang hood from screws and |
| tighten securely. |
5. | From inside of hood, insert |
| screws supplied. Drill through |
| holes (use #8 x 5/8" screws |
| supplied), one (1) on each side |
| and four along the front, into |
Figure 10: Tap Hole and Screw Hole Locations
Centerline Hole Dimensions for Figures 10 and 11
HOOD | A (Fig 10) | B (Fig 11) |
SIZE | Tap Holes | Conduit Hole |
|
|
|
30" | ||
36" | 167/16" | |
42" | ||
48" | ||
54" |
bottom of the cabinet. See |
screw holes labeled "L" in |
Figure 10. |
1
Wall
Cooktop
Centerline
23" | B | 2 | |
| |||
|
| ||
| 7 7/8" | 1- 7/8" | |
|
| ||
| 2 3/8" |
| |
3 | 5/8" DIA clearance |
| |
holes for 1/2" conduit | |||
| |||
| to |
|
Plan View of Cabinet Cutout
Note: This figure depicts transition and conduit locations only. See Figure 1b, page 4 for overall hood dimensions.
Figure 11: Transition and Conduit Locations
8