GE GFK-0726B manual Battery

Page 15

2

Battery

The State Logic Processor comes with a 3 volt lithium battery (IC697ACC701) to maintain memory through a power cycle. If the battery charge becomes low, a fault is set in the fault table. These faults can be monitored by the State Logic program.

To replace the battery, connect the new battery to the extra set of battery connections then disconnect the old battery. A Product Safety Data Sheet for the battery is available. Order from GE Fanuc using number GFK-0633.

GFK-0726B

Chapter 2 Installation and Maintenance

2-3

Image 15

Contents GE Fanuc Automation GFL±002 GE Fanuc Automation North America, Inc Page We Welcome Your Comments and Suggestions Content of this ManualContents SampleLogicmasterConfigurationScreen Contents Chapter State Logic Processor Description GFK-0726B Physical DescriptionSeries 90-30 State Logic Processor Operational Description Chapter Installation and Maintenance Selecting the Right SlotInserting the SLP Sample Logicmaster Configuration Screen ConfigurationBattery Chapter Troubleshooting Serial Communication ProblemsStatus LED is not on Steady Communications Problems with Another Serial Device Communications Problems with ECLiPS or OnTOPChapter SerialCommunications Programming Serial Communications Serial Port Setup Programmable Setup OptionsECLiPSor OnTOP Options Serial Port Parameters Mini Converter Kit Serial CableRTS CTS DTR GND PCM Other Cable OptionsCustom Made Cables No Connection Signal GroundWYE Cable Connections for Series 90-30 SLP HardwareSpecifications Chapter SpecificationsFirmware Specifications SLP I/O and Register Specifications