3 |
Output Data Area Tab
The output data area describes data sent over the network by the Slave module to the PROFIBUS Master. These outputs are mapped, using the Output Data Area tab, from specific memory locations in the PLC where the Slave module resides.
Area | |
Type | Data type of area being defined. Valid types are Digital Out, Analog Out, and Empty. The default value is |
| Empty. |
Size | Describes the size of the data area on the network. Set to 0 and |
| ranges: |
If Type is set to Digital Out (Byte):
If Type is set to Analog Out (Word):
Note: The total number of output bytes for all entries cannot exceed 244.
Units | This |
| If Type is set to Empty or Digital Out: Byte |
| If Type is set to Analog Out: Word |
Ref | Location in PLC memory where the data to be sent is mapped. This field is |
Address | This is a produced range and can be any range in %AI, %I, %Q, %G, %AQ, %R, %T, or %M. If Type is |
| Digital Out and the number of bytes (Size) is odd, an address in discrete memory must be used: %I, %Q, |
| %G, %M, or %T. Overlaps with another produced range are not considered fatal and can be included in a |
| valid configuration. |
| Default: For Digital Out, next available address in %Q |
| For Analog Out, next available address in %AQ |
Length | The length of the reference mapped to the area. |
Allowable ranges:For discrete memories: 0, 8, 16 ... X For register memories: 0, 1, 2 ... X
where X is the required length to hold the entire data area. The default value is the space required to map bytes specified by the entries in Type and Size.
Note: If an output data area is defined (Type and Size are specified) but Length is set to 0, a value of 0 is sent to the Master for that data area.
Power Consumption Tab
The information in this tab is
Series |