Gefen EXT-HDMI1.3-442 user manual Operation Notes

Page 5

OPERATION NOTES

READ THESE NOTES BEFORE INSTALLING OR

OPERATING THE 4X2 SWITCHER FOR HDMI 1.3

By default, display information from the display connected to HDMI output port 1 is sent back to the source. Therefore, the other display connected to the 4x2 Switcher for HDMI 1.3 must be capable of accepting the timings, resolutions and audio formats of the display that is connected to HDMI output port 1. It is recommended that the display with the lowest native resolution be connected to HDMI output port 1. This is to ensure that a compatible video signal will be able to be displayed on all connected monitors. There is a generic EDID programmed into the 4x2 Switcher for HDMI 1.3 that can be used instead. See page 11 for more details.

2

Image 5
Contents 4x2 Switcher for Hdmi Technical Support Asking for AssistanceTechnical Support Hours Write ToContents Introduction Gefen 4x2 Switcher for HdmiGefen How It WorksOperation Notes Features FeaturesHdmi 1.3 Features Panel Layout Panel Descriptions Power IndicatorWiring Diagram for the Gefen 4x2 Switcher for Hdmi Connecting and Operating 4X2 Switcher for HdmiHow to Connect the 4x2 Switcher for Hdmi IR Remote Description RMT-4IR Remote Control UnitInstalling the IR Remote Control Battery IR Remote InstallationSetting the IR Remote Channel on the RMT-8IR IR Remote ConfigurationSetting The IR Channel IR Channel ConfigurationEdid Management Edid Mode SelectionTiming Refresh Rate Audio Format Supported ChannelsDisplay Connections Following Edid features are copied from OutputExternal Edid Management 5V DC SpecificationsProduct Registration WarrantyRev B3 Nordhoff St., Chatsworth CA