Gefen 4x1 DVI Switcher user manual RMT4-IR Installation

Page 8

RMT4-IR Installation

1.Remove battery cover from the back of the RMT4-IR remote.

2.Verify that dip switches 1 & 2 are in the down (OFF) position.

3.Insert the battery, hold the battery so that you can see the positive side facing up. The side that is not marked must be facing down.

4.Test the RMT4-IR remote by pressing ONLY one button at a time. The indicator light on the remote will flash once each time you press a button. WARNING: Do not press multiple buttons simultaneously and do NOT press buttons rapidly. These actions will cause the remote to reset and steps 1-4 will have to be repeated.

Note: The RMT4-IR ships with two batteries. One battery is required for operation, the second battery is complimentary.

5

Image 8
Contents 4x1 DVI Switcher Asking for Assistance Technical SupportTechnical Support Hours Write ToTable of Contents Introduction Includes FeaturesFeatures Panel Descriptions Operation Notes How to Connect the 4x1 DVI Switcher to your devicesHow to Operate the 4x1 DVI Switcher RMT4-IR Installation Binary Table RS232 SettingsRS-232 Interface Specifications Warranty Ma-DVI-441N