NAT/Route mode installation | Configuring the FortiGate unit |
config system interface edit <interface>
set mode static
set ip <address_ip> <netmask>
end
Example
config system interface edit internal
set mode static
set ip 192.168.120.99 255.255.255.0
end
3Set the IP address and netmask of the external interface to the external IP address and netmask you recorded in Table 12 on page 36.
config system interface edit <interface>
set mode static
set ip <address_ip> <netmask>
end
Example
config system interface edit external
set mode static
set ip 10.10.1.5 255.255.255.0
end
To set the external interface to use DHCP, enter:
config system interface edit <interface>
set mode dhcp
end
To set the external interface to use PPPoE, enter:
config system interface edit <interface>
set mode pppoe
set connection enable set username <name_str> set password <psswrd>
end
4Use the same syntax to set the IP address of each FortiGate interface as required.
5Confirm that the addresses are correct. Enter:
get system interface
The CLI lists the IP address, netmask, and other settings for each of the FortiGate interfaces.
To configure DNS server settings
Set the primary and secondary DNS server IP addresses. Enter
40 | |