15.LCD Metering Display - When the UPS is turned on, this portion of the LCD display indicates the AC output voltage initially. Depressing the downward scroll button will indicate the following each time it is depressed:
LCD Metering Display Modes
(use display scroll buttons to change modes; modes are in descending order)
Mode | Value | Display Description |
AC Output | Voltage | AC Output Voltage |
AC Input | Voltage | AC Input Voltage |
AC Output | Frequency (Hz) | AC Output Frequency |
Battery | Voltage | DC Battery Voltage |
Temperature | ºC | Internal UPS Temperature |
Timer | Minutes to off | The UPS will turn off when the displayed |
|
| value reaches zero. |
Timer | Hours to on | The UPS will turn on when the display |
|
| reaches zero. |
Battery | Minutes to off | The estimated remaining battery run time |
|
| while in battery backup mode. |
Step 1C
JUMPER
TYPICAL UPS REAR PANEL
65 | 5 |
| 4 |
2 |
|
|
3 |
|
|
|
| 4 |
|
| 3 |
2 | 1 | JUMPER SLOT |
|
| Battery Fuse |
NEMA Type
IEC Type
1.
Battery Disconnect Jumper - To install the Jumper use the following procedure.
a)Using a #1 Phillips screwdriver remove the two screws securing the battery disconnect cover.
b)Remove the battery disconnect jumper plug from the plastic bag.
c)Press the disconnect jumper into the socket visible through the hole exposed after removal of the cover. A small popping sound may occur; this is normal.
9