Environmental Performance, Pin Connector

FTLX1461E2 Product Specification – October 2008

Environmental Performance
Operating case temperature:	0°C to +70°C
Operating humidity:	0% -95% RH non-condensing

Fibers and Connectors

The transponder has SC receptacles for both Tx and Rx. The transponder is designed for single mode SC cables, 0° polished endface (PC).

70-pin Connector

The module interface connector is a 70-pin, printed circuit board edge connection with a 0.5 mm pitch. The appropriate mating connector for the customer PCB is a 70-pin SMT, dual row, right angled, edge connector, 0.5 mm pitch (Tyco Electronics part number 1367337-1, Molex part number 74441-0003 or equivalent).

Rail Requirement

The XENPAK rail system required to mount the XENPAK module is fully defined by the MSA.

Aqueous Wash

Finisar XENPAK transponders are neither solderable nor aqueous washable and are not intended for these processes.

VI.	Regulatory Compliance

Feature		Standard	Comments
ESD:		EIA/JESD22-A114-B	Class 1a (> 500 V)
Electrostatic Discharge to the		(MIL-STD 883D
Electrical Pins (HBM)		Method 3015.7)
Immunity:		EN 61000-4-2	Discharges ranging from ±2 kV to ±25 kV to
Against Electrostatic Discharge		IEC 61000-4-2	the front end / faceplate / receptacle cause no
(ESD) to the Module Receptacle			damage to module (under recommended
			conditions).
Immunity:		EN 61000-4-3	With a field strength of 10 V/m, noise
Against Radio Frequency		IEC 61000-4-3	frequency ranges from 10 MHz to 2 GHz. No
Electromagnetic Field			effect on module performance between the
			specification limits.
Emission:		FCC 47 CFR	Noise frequency range:
Electromagnetic Interference		Part 15, Class B	30 MHz to 40 GHz
(EMI)		EN 55022 Class B	Radiated emission does not exceed specified
		CISPR 22	limits when measured inside a shielding
			enclosure with MSA conform cutout.

Rev B

Page 8