Extreme Networks WM-4T1i manual Contents

Page 3

Contents

Preface

Introduction	v
Conventions	vi
Related Publications	vii

1 Installing the WM-4T1i Module

Overview	1-1
Installing the WM-4T1i Module	1-2
Ports and Connectors	1-3
WM-4T1i Module LEDs	1-3
Installing the WM-4T1i Module Software	1-5

2 Configuring the T1 Physical Link

Overview	2-1
Configuring T1 Physical link	2-1
Alarms	2-2
Cable length	2-2
Clock Source	2-3
Facility Data Link	2-3
Framing	2-4
Inband Loopback Detection	2-4
Linecoding	2-4

WM-4T1i Installation and User Guide

iii

Image 3

Contents WM-4T1i Module Installation and User Guide Page Contents Index Index of Commands Introduction PrefaceText Conventions ConventionsRelated Publications Viii WM-4T1i Module Installation and User Guide Overview Installing the WM-4T1i ModuleInstalling the WM-4T1i Module WM-4T1i Module LEDs Ports and ConnectorsLED 1WM-4T1i Module LEDsInstalling the WM-4T1i Module Software Use image primary secondary Configuring T1 Physical link Configuring the T1 Physical LinkCable length AlarmsClock Source Facility Data LinkFraming Inband Loopback DetectionLinecoding Yellow Alarms T1 Port Configuration Commands1T1 Port Configuration Commands Monitoring T1 Physical Link LoopbackData Data out Framer Data with framing Framer Data out Data Data out FramerFar-End Loopback Modes 6Remote payload loopback mode 5Remote line loopback mode2T1 Port Monitoring Commands T1 Port Monitoring Commands2T1 Port Monitoring Commands Configuring the T1 Physical Link Configuring PPP and Mlppp Multilink PPP and Multilink Groups Authentication Configuring a PPP/MLPPP LinkPPP User Accounts Encapsulation1PPP/MLPPP Configuration Commands PPP/MLPPP Configuration CommandsMonitoring PPP/MLPPP Links PPP/MLPPP Configuration ExamplesConfiguring a Bridged PPP/MLPPP Link Example 2PPP/MLPPP Show CommandsConfiguring a Routed PPP/MLPPP Link Example Switch #1Switch 2IPCP multilink example Numerics IndexPAP Index of Commands Ii Index of Commands