Monitoring PPP/MLPPP Links

Configuring PPP and MLPPP

Table 3-1:PPP/MLPPP Configuration Commands (continued)

Command	Description

restart multilink <groupname>	Restarts multilink group. Configuration changes
	made to an enable multilink group will not take
	effect until the group is restarted.
unconfig ppp port <portlist>	Resets the port to the default PPP
	configuration; no authentication and BCP
	encapsulation.

The following commands monitor the status of the PPP and MLPPP links.

Table 3-2:PPP/MLPPP Show Commands

Command

Description

show multilink <groupname>

show multilink [<groupname>] stats {detail} show multilink [<groupname>] t1 alarms {detail}

show multilink [<groupname>] t1 errors [near-end far-end] [totals intervals current]

show ppp {<portlist>} {detail} show accounts pppuser

Displays the configuration of the multilink group.

Displays multlink group statistics.

Displays T1 alarm status for multilink groups.

Displays T1 error statistics for a multilink group.

Shows PPP configurations.

Show the PPP accounts on the switch.

PPP/MLPPP Configuration Examples

The following examples show how to configure multilink groups.

Configuring a Bridged PPP/MLPPP Link Example

The following example shows how to configure a BCP-encapsulated multilink group. BCP is the default encapsulation, so it is not explicitly included in this example. The config ports t1 clocksource command is included to show where you might need to configure the T1 parameters for your link. Each T1 port in the multilink group will

3-6	WM-4T1i Module Installation and User Guide