Encore electronic ENMGS-24+4 manual FCC Certifications, CE Mark Warning

Page 2

FCC Certifications

This Equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and

(2)this device must accept any interference received; including interference that may cause undesired operation.

CE Mark Warning

This equipment complies with the requirements relating to electromagnetic compatibility, EN 55022 class A for ITE, the essential protection requirement of Council Directive 89/336/EEC on the approximation of the laws of the Member States relating to electromagnetic compatibility.

Company has an on-going policy of upgrading its products and it may be possible that information in this document is not up-to-date. Please check with your local distributors for the latest information. No part of this document can be copied or reproduced in any form without written consent from the company.

Trademarks:

All trade names and trademarks are the properties of their respective companies.

Copyright © 2006, All Rights Reserved.

1

Image 2
Contents ENMGS-24+4 FCC Certifications CE Mark WarningTable of Contents Product Specifications Appendix Command Line Interface General Description Unpacking InformationIntroduction Front Panel Key FeaturesPower LEDs DefinitionPort Operation 1000M10/100M Rear Panel Restore Default ButtonPower Receptacle Rack-mount Installation InstallationDesktop Installation Installing Network Cables Media Speed WiringFunctional Description Management guide Access the management interface of the SwitchManage the device via command line interface Manage the device via WEB browserPage Homepage System Items FunctionsPort Functioning Vlan Page Pvid Aggregation/ Trunk Configuration Quality of Service Port-based mode QoSTag based QoS Dscp mode QoS Bit 0 Delay Bit 1 Throughput Bit 3 ReliabilityMirror Configuration Rate Limit Snmp Manual Add DiscoveryAuto Search DeleteStatistics Overview Detailed StatisticsRestore Factory Default Factory DefaultSmart Boot RestartSoftware Upload Rate Product SpecificationsTemperature LED indications SystemLogin/Logout Procedures Appendix- Command Line InterfaceStart-up and Terminal configuration Command Hierarchy Entering CommandsCommand Description System CommandsConsole Commands Port Mode portlist mode Port CommandsPort Configuration portlist Port Flow Control portlist enabledisablePort Statistics portlist clear Port Admin portlist enabledisablePort MaxFrame portlist framesizereset Vlan Add vidlist portlist Vlan CommandsVlan Configuration portlist Vlan Delete vidlistVlan Pvid portlist vidnone Vlan OnlyTag portlist enabledisableVlan Egress portlist untaggedtagged Aggr Mode smacdmacxor Aggregation CommandsAggr Configuration Aggr Delete portlistQoS Mode portlist tagportdiffserv QoS CommandsQoS Configuration portlist QoS Port portlist classQoS DiffServ dscpno class Mirror CommandsMirror Source portlist enabledisable Mirror Port portIP Commands Snmp CommandsRatelimit Configuration Ratelimit CommandsSnmp Setup enabledisable Ratelimit Setup traffic type optionRatelimit Egress portlist enabledisable rate Ratelimit Ingressportlist enabledisable rate