Encore electronic ENMGS-24+4 Port Commands, Port Configuration portlist, Port Mode portlist mode

Page 37

Port Commands

Commands at Port level:

Port Configuration [<portlist>] Port Mode [<portlist>] [<mode>]

Port Flow Control [<portlist>] [enabledisable] Port Admin [<portlist>] [enabledisable]

Port MaxFrame [<portlist>] [<framesize>reset] Port Statistics [<portlist>] [clear]

------

#Note: If your want to change maxframe bigger than 1518. The [Flow Control] should be enabled!

Port Configuration [<portlist>]

Description:

Show the configured and current speed, duplex mode, flow control mode and admin state for the port.

[<portlist>]: Port list (Default: All ports).

Port Mode [<portlist>] [<mode>]

Description:

Set or show the speed and duplex mode for the port.

[<portlist>]: Port list (Default: All ports).

[<mode>]

: Port speed and duplex mode (Default: Show configured

 

and current mode).

 

10hdx

: 10 Mbit/s, half duplex.

 

10fdx

: 10 Mbit/s, full duplex.

 

100hdx : 100 Mbit/s, half duplex.

 

100fdx : 100 Mbit/s, full duplex.

 

1000fdx: 1 Gbit/s, full duplex.

 

auto

: Auto negotiation of speed and duplex.

Port Flow Control [<portlist>] [enabledisable]

Description:

Set or show flow control mode for the port.

[<portlist>] : Port list (default: All ports).

[enabledisable]: Enable/disable flow control (default: Show flow control mode).

36

Image 37
Contents ENMGS-24+4 CE Mark Warning FCC CertificationsTable of Contents Product Specifications Appendix Command Line Interface Introduction Unpacking InformationGeneral Description Power Key FeaturesFront Panel LEDs Definition10/100M 1000MPort Operation Power Receptacle Restore Default ButtonRear Panel Desktop Installation InstallationRack-mount Installation Media Speed Wiring Installing Network CablesFunctional Description Manage the device via command line interface Access the management interface of the SwitchManagement guide Manage the device via WEB browserPage Homepage Items Functions SystemPort Functioning Vlan Page Pvid Aggregation/ Trunk Configuration Port-based mode QoS Quality of ServiceTag based QoS Bit 0 Delay Bit 1 Throughput Bit 3 Reliability Dscp mode QoSMirror Configuration Rate Limit Snmp Auto Search DiscoveryManual Add DeleteDetailed Statistics Statistics OverviewSmart Boot Factory DefaultRestore Factory Default RestartSoftware Upload Temperature Product SpecificationsRate LED indications SystemStart-up and Terminal configuration Appendix- Command Line InterfaceLogin/Logout Procedures Entering Commands Command HierarchySystem Commands Command DescriptionConsole Commands Port Configuration portlist Port CommandsPort Mode portlist mode Port Flow Control portlist enabledisablePort MaxFrame portlist framesizereset Port Admin portlist enabledisablePort Statistics portlist clear Vlan Configuration portlist Vlan CommandsVlan Add vidlist portlist Vlan Delete vidlistVlan Egress portlist untaggedtagged Vlan OnlyTag portlist enabledisableVlan Pvid portlist vidnone Aggr Configuration Aggregation CommandsAggr Mode smacdmacxor Aggr Delete portlistQoS Configuration portlist QoS CommandsQoS Mode portlist tagportdiffserv QoS Port portlist classMirror Source portlist enabledisable Mirror CommandsQoS DiffServ dscpno class Mirror Port portSnmp Commands IP CommandsSnmp Setup enabledisable Ratelimit CommandsRatelimit Configuration Ratelimit Setup traffic type optionRatelimit Ingressportlist enabledisable rate Ratelimit Egress portlist enabledisable rate