Encore electronic ENMGS-24+4 manual Rear Panel, Restore Default Button, Power Receptacle

Page 8

Restore Default Button

You can use this button to reset the switch or restore factory default settings. To reset the switch, press the button once.

To restore factory default settings, press and hold the button for three seconds.

The Rear Panel

The rear panel of the switch:

Power Receptacle

To be compatible with the electric service standards around the world, the switch is designed to afford the power supply in the range from100 to 240VAC, 50/60Hz. Please make sure that your outlet standard to be within this range.

To power on the switch, please plug the female end of the power cord firmly into the receptacle of the switch and the other end into an electric service outlet. After the power cord installation, please check if the power LED is lit for a normal power status.

Image 8

Contents ENMGS-24+4 FCC Certifications CE Mark WarningTable of Contents Product Specifications Appendix Command Line Interface General Description Unpacking InformationIntroduction Key Features PowerFront Panel LEDs DefinitionPort Operation 1000M10/100M Rear Panel Restore Default ButtonPower Receptacle Rack-mount Installation InstallationDesktop Installation Installing Network Cables Media Speed WiringFunctional Description Access the management interface of the Switch Manage the device via command line interfaceManagement guide Manage the device via WEB browserPage Homepage System Items FunctionsPort Functioning Vlan Page Pvid Aggregation/ Trunk Configuration Quality of Service Port-based mode QoSTag based QoS Dscp mode QoS Bit 0 Delay Bit 1 Throughput Bit 3 ReliabilityMirror Configuration Rate Limit Snmp Discovery Auto SearchManual Add DeleteStatistics Overview Detailed StatisticsFactory Default Smart BootRestore Factory Default RestartSoftware Upload Product Specifications TemperatureRate LED indications SystemLogin/Logout Procedures Appendix- Command Line InterfaceStart-up and Terminal configuration Command Hierarchy Entering CommandsCommand Description System CommandsConsole Commands Port Commands Port Configuration portlistPort Mode portlist mode Port Flow Control portlist enabledisablePort Statistics portlist clear Port Admin portlist enabledisablePort MaxFrame portlist framesizereset Vlan Commands Vlan Configuration portlistVlan Add vidlist portlist Vlan Delete vidlistVlan Pvid portlist vidnone Vlan OnlyTag portlist enabledisableVlan Egress portlist untaggedtagged Aggregation Commands Aggr ConfigurationAggr Mode smacdmacxor Aggr Delete portlistQoS Commands QoS Configuration portlistQoS Mode portlist tagportdiffserv QoS Port portlist classMirror Commands Mirror Source portlist enabledisableQoS DiffServ dscpno class Mirror Port portIP Commands Snmp CommandsRatelimit Commands Snmp Setup enabledisableRatelimit Configuration Ratelimit Setup traffic type optionRatelimit Egress portlist enabledisable rate Ratelimit Ingressportlist enabledisable rate