Connection Type: Select Continuous (always online), Connect on Demand (connect to the ISP only when you click on a website), or Manual (connect to the ISP only when you click on a ‘Connect’ button) from the
Idle Time: The PPPoE service can automatically disconnect if the connection is idle. Specify the number of minutes after between 1 and 100.
DNS: The ISP usually automatically assigns the DNS IP address, in case you need to assign it manually then click on the Set DNS Manually and fill in the fields.
MTU: You may adjust the Maximum Transmit Unit (MTU), however it is recommend
that this value is set to the default: 1500 bytes
DNS
Clone MAC Address: Specify a MAC address if you would like to use a different MAC address on this device. (optional)
Enable uPNP: Place a check in this box to enable UPnP. It is recommended to enable this feature as it’s used by several applications.
Enable PING Access on WAN: Place a check in this box if you would like the device to be pinged from the WAN side (ISP).
Enable Web Sever Access on WAN: Place a check in this box if the static IP address if used for a
Enable IPsec pass through on VPN connection: Place a check in this box to enable the pass through of IPsec packets on a VPN connection.
Enable IPsec pass through on VPN connection: Place a check in this box to enable the pass through of PPTP packets on a VPN connection.
Enable IPsec pass through on VPN connection: Place a check in this box to enable the pass through of L2TP packets on a VPN connection.
Click on the Apply Changesto save the changes.
WAN Settings – PPTP
Click on the WAN link on the navigation
26