Enterasys Networks Wireless Ethernet Adapter I manual Error Code Problem Steps to take

Error Code	Problem	Steps to take
xxxx: [yyyy]: “zzzz”: entry	Entry zzzz in sec-	• Check the entry in the
is invalid	tion yyyy of file	configuration for zzzz.
		• If you cannot find zzzz in the
	xxxx contains an
	invalid value.	Ethernet Adapter Manager
		program, you may have to use
		the serial port or telnet
		configuration menus. See
		Appendix A for details.
Unable to bring up interface	Configuration	Check the configuration for the
“lanX”.	values for the radio	PCMCIA radio card used.
	may be incorrect.

Xxxx: <[yyyy]zzzz>:	Route values are out
Unable to add route.	of range compared to
	the interface values.

•Set the route value to “automatic.”

•If “automatic” does not work for your Ethernet Adapter, check the values you set for the route to make sure they correspond to your other IP parameters.

UART Error – No Rx Buffer	Data is being sent to
Available	the UART at a rate
	faster than it can
	clear its receive buff-
	ers, and data is being
	lost.

•Enable flow control for your serial application.

•Note: If you are using the serial port menu system for configuration, flow control will not be enabled in the Ethernet Adapter. To avoid getting this while in the serial port configuration system, type slower.

Any other errors	•	If the event log instructs you
		to contact Technical Support,
		please do so now before
		continuing.
	•	Reset the Ethernet Adapter.

B-5