Enterasys Networks BL-69551ENT, BL-69108ENT manual Detection Sequence

Page 26

Powering Up

Detection Sequence

Once a compliant load is attached to the output RJ45 connector, the green “CONNECT” LED will illuminate.

Should the load be non‐compliant, then the LEDs will blink a code signifying the cause for non‐detection.

Detection Failure Codes

1.Incorrect resistive signature – The green “CONNECT” and red “FAULT” LEDs will blink 3 times.

2.Incorrect capacitive signature – The green “ON” LED will blink 3 times.

3.Incorrect Voffset – The green “CONNECT” and green “ON” LEDs will blink 3 times.

4.Unstable current measurement – The green “ON” LED will blink 3 times.

5.Low voltage sensed during detection (overload) – The red “FAULT” LED will blink 3 times.

After the LEDs blink 3 times the BL‐69551ENT will continue to try to detect a valid load. Therefore, until the correct load is applied, the LEDs will continue to blink. If there is an open circuit connected to the output RJ45, then the LEDs will not blink but the BL‐69551ENT will continue to try to detect a valid load.

Fault Sequence

Should there be a fault such as an overload or short circuit, then the red “FAULT” LED will illuminate. The red “FAULT” LED will illuminate for 2 seconds and then go off as the power supply tries to re‐detect a valid load. If there is a problem in detecting, the LED will indicate what is wrong with the load as per the codes in the section above.

2-4 Installation and Connection

Image 26
Contents Single-Port Power Over Ethernet Adapter Page Page Regulatory Compliance Information Seguridad del Producto Hazardous Substances Vcci Notice 73/23/EEC ONE-YEAR Limited Warranty Enterasys Networks, Inc Firmware License Agreement Page Page Page Xii Contents Figures Who Should Use This Guide About This GuidePurpose Document Conventions Following conventions are used in this guideGetting Help Xviii About This Guide Functions and Features IntroductionInput Connector Installation and Connection Verifying the Kit ContentsTechnical Considerations Powering Up OutDetection Sequence Troubleshooting ChecklistRBT3K Troubleshooting Checklist Checklist Troubleshooting Hardware Specifications Regulatory Compliance StandardsSafety Approvals Output SpecificationsPhysical/Environmental Specifications InputOutput Isolation Test