Dish Network DP21 manual Wiring Diagrams, Operating with a DishPro Compliant Splitter

Page 10

7.If you still do not see the Satellite reception verified message, call the DISH Network Customer Service Center at 1-800-333- DISH (3474).

Operating with a DishPro Compliant Splitter

When using a DishPro compliant splitter to split the signal from a DishPro single LNBF (as shown in Figures 4 and 5), the receiver whose DP21 switch is connected to the passing side of the splitter must be plugged into a live power outlet at all times. If not, the DishPro single LNBF will not have any power and will not be able to provide satellite signal to the other receiver.

Wiring Diagrams

The wiring diagrams that begin on page 11 omit cable drip loops and grounding for clarity. Make sure to use drip loops, and to ground the system per the National Electrical Code (NEC) and all local electrical codes.

The wiring diagrams that begin on page 11 show optional splitters between the LNBFs and the DP21. Only use DishPro compliant splitters. Use of splitters that are not DishPro compliant may cause undesirable operation, including loss of channels, black screens, and incorrect Check Switch results.

10

Image 10
Contents DishPro 21 Multi-Dish Switch Installation Guide Important Safety Instructions Important Regulatory FactorsContents Introduction How to Install a DP21 Switch ConnectionsRun Check Switch Point Dish/Signal Installation Summary with Identified Devices Installation Summary without Identified Devices Wiring Diagrams Operating with a DishPro Compliant SplitterPage Page Page Limited Warranty Advance Exchange Program Post Receipt Exchange Program Accessory Warranty If You Need HelpFCC Information