deXlan 068420 user manual

Page 25

IP POWER 9258 USER MANUAL

Note: program “Make9258Html.exe “ and amend webpage must in same file.

*If update fail and can not get IP address by IP EDIT , please use RS232 jack ( DB 9 Cable) connect with the PC and 9258, and you can get IP address to log-in and update again. Please refer follow step:

1.POWER OFF the 9258

2.Use DB9 cable connect to the COM1 of PC and the RS232 of 9258

3.Execute WIN program " Hyper Terminal" : please go to " Start" --> " program" " Accessories " --> " Communications " “Hyper Terminal” .

Set the “Bits per second” as 19200 at COM1 ( Must at COM1)

4.Then power ON 9258 you will get message in Hyper Terminal .

5.Please check the message and get your IP address.

- 24 -

Image 25

Contents IP Power IP Power Important Notice Table of Content Introduction SpecificationPackage contents SpecificationMinimum System Requirements Interface Description Hardware installation Hardware & Software installationSoftware installation For 100-120V, please use power wire can support 15A currentInitial setting through the Ethernet Initial SettingsUsername admin Password Control the power supply of outlets Control and settings through the Internet ExploreSystem Settings Power Supply State QuerySetting the password for IP Power Setting the IP address for IP PowerPage Email Settings Setup up own outlet default status Control the IP Power 9258 through Time ScheduleInternal Clock Settings & Network Time Protocol NTP Wake on Lan WOL Page Gprs for Cell Phone Support WAP Check 9258 status though Snmp Function Control and Settings Through Http OrderPARAM=* time schedule parameter . Parameter list as follow YY=****+MM=**+DD=**+HH=**+MN=**+SS=* time parameterWebpage Customization FAQEach file do not over the original file size Page VER Page VER