Intelligent Technologies (IT.) QSNAP
February 2002
SW1 Settings
SW1 is used to set the existence of the second Aux contact and the external ground fault.
Table 16: SW1 Settings
SW1 Position | Event | |
|
|
|
|
|
|
A | 0 | = no second Aux installed, 1 = second Aux installed |
|
|
|
B | 0 | = no ground fault installed, 1 = ground fault installed |
|
|
|
Mount the IT. QSNAP to the Starter
The IT. QSNAP is designed to be installed in the auxiliary contact locations of the IT. family of starters as illustrated in Figure 6. On all starters, one or more auxiliaries can be used along with the QSNAP. Table 17 lists starters and indicates the number of available auxiliary locations for each.
Table 17: Starter Size/Available Auxiliary Locations on Mounted QSNAP
| Number of Available Auxiliary Locations |
Starter Frame Size (mm) | when Center Mounted |
|
|
|
|
45 | 1 single |
|
|
54 | 1 single or 1 dual |
|
|
76 | 2 single or 2 dual |
|
|
105 | 2 single or 2 dual |
|
|
140 | 2 single or 2 dual |
|
|
Figure 6: QSNAP with
54 mm IT. Starter
16 | Pub. No. MN05001001E |