Eaton Electrical QSNAP Wire the IT. Qsnap to the Starter, Terminal Block Wiring, Starter RJ-45

Intelligent Technologies (IT.) QSNAP

February 2002

Wire the IT. QSNAP to the Starter

The QSNAP is connected to the IT. starter using a factory-provided jumper with an RJ-45 plug on one end and a pigtail on the other. The pigtail is color coded to facilitate accurate connection to the overload terminal block. Refer to the following figure and table when wiring the terminal block.

1

1

RJ-45 Plug

1

Figure 9: Jumper and RJ-45 Plug
Table 18: Terminal Block Wiring
Starter	RJ-45
GND	1
+24	2
P	3
F	4
R	5
1	6
2	7
3	8

Use the following steps and illustrations to install the jumper.

1.Once the jumper is wired, insert the terminal block into the overload and the RJ-45 connector into J3 on the QSNAP as illustrated in Figure 10: Jumper Installation.

QSNAP

Jumper

IT. Starter Terminal Block

Figure 10: Jumper Installation

18 Pub. No. MN05001001E