Eaton Electrical QSNAP user manual Safety

Page 7

Intelligent Technologies (IT.) QSNAP

February 2002

Safety

The following safety statements relate to the installation, setup and operation of Eaton’s Cutler-Hammer IT. QSNAP and Starter.

Notice

Make sure you read and understand the installation procedures in this manual before you attempt to operate or set up the equipment.

WARNING

This instruction manual should be used for proper installation, setup and operation of the IT. QSNAP. Improperly installing and maintaining this product can result in serious personal injury or property damage. Before attempting installation, setup or operation, read and understand this entire manual.

WARNING

Hazardous voltage can cause electric shock and burns. Always disconnect power before proceeding with any work on this product.

CAUTION

Only apply 24V DC to the QSNAP power terminals. Use of any other voltage may result in personal injury, property damage and damage to the IT. QSNAP.

WARNING

To provide continued protection against fire or shock hazard, the complete IT. QSNAP must be replaced if it becomes inoperative.

Pub. No. MN05001001E

3

Image 7
Contents Intelligent Technologies Important Notice Please Read Table of Contents List of Figures List of TablesQsnap S751 Connectivity Table Product OverviewDescription Qsnap Electromechanical Starter Connectivity TableFeatures and Benefits Safety Environmental Ratings Environmental RatingsApprovals/Certifications Catalog Numbering SystemDimensions Physical FeaturesPhysical Description Load Power SourcePower Requirements Current SourceQsnap Out of Box Operation Default Input Data from QsnapDefault Output Data to Qsnap OperationTypical Qsnap Application Typical ApplicationFault Definition Enhanced FeaturesStandard Features Enhanced FeaturesInput/Output Data Input Assembly Data DefinitionsData Description Default Output Data Default Input DataOutput Assembly Data Definitions Qsnap Truth Table Status LEDTruth Table Status LEDConfiguration Using CH StudioSet the Group ID InstallationStarter Size/Available Auxiliary Locations on Mounted Qsnap SW1 SettingsSW1 Settings Mount the IT. Qsnap to the StarterQsnap Alignment and Mounting Terminal Block Wiring Wire the IT. Qsnap to the StarterStarter RJ-45 QCPort Connection Connect the Qsnap to QCPortRenewal Parts Troubleshooting and MaintenanceTroubleshooting TroubleshootingConfiguration Parameters Appendix a Qsnap ParametersNumber Parameter Length Units Number Parameter Units Length Data ParametersIT. Publications Intelligent Technologies IT. Publications and SupportPublication Description Intelligent Technologies IT. Qsnap Page Response network that gives new meaning to customer service Eaton’s Cutler-Hammer Aftermarket Services