Eaton Electrical QSNAP user manual Qsnap Alignment and Mounting

Page 21

Intelligent Technologies (IT.) QSNAP

February 2002

Use the following steps and the illustration in Figure 7 to mount the QSNAP.

1.Align both the QSNAP feet with the auxiliary contact mounting slots on the starter, as illustrated in the figure.

Recommendation: Use the middle mounting auxiliary contact on the contact block when mounting the QSNAP.

2.When the QSNAP is aligned, insert the feet into the detents and slide the QSNAP towards the overload until a “click” is heard. This ensures that the QSNAP is mounted securely to the starter.

1. Align and

Insert

2. Slide

Figure 7: QSNAP Alignment and Mounting

Note: To remove the QSNAP, press the “PUSH” tab protruding from the QSNAP while sliding the QSNAP up and pulling away from the contactor block, as illustrated in Figure 8.

1. Slide

2. Pull

 

Away

Figure 8: QSNAP Removal

Pub. No. MN05001001E

17

Image 21
Contents Intelligent Technologies Important Notice Please Read Table of Contents List of Figures List of TablesDescription Product OverviewQsnap Electromechanical Starter Connectivity Table Qsnap S751 Connectivity TableFeatures and Benefits Safety Approvals/Certifications Environmental RatingsCatalog Numbering System Environmental RatingsPhysical Features DimensionsPhysical Description Power Requirements Power SourceCurrent Source LoadQsnap Default Output Data to Qsnap Default Input Data from QsnapOperation Out of Box OperationTypical Qsnap Application Typical ApplicationStandard Features Enhanced FeaturesEnhanced Features Fault DefinitionInput Assembly Data Definitions Input/Output DataData Description Default Input Data Default Output DataOutput Assembly Data Definitions Truth Table Status LEDStatus LED Qsnap Truth TableConfiguration Using CH StudioSet the Group ID InstallationSW1 Settings SW1 SettingsMount the IT. Qsnap to the Starter Starter Size/Available Auxiliary Locations on Mounted QsnapQsnap Alignment and Mounting Wire the IT. Qsnap to the Starter Terminal Block WiringStarter RJ-45 QCPort Connection Connect the Qsnap to QCPortTroubleshooting Troubleshooting and MaintenanceTroubleshooting Renewal PartsAppendix a Qsnap Parameters Configuration ParametersNumber Parameter Length Units Number Parameter Units Length Data ParametersIntelligent Technologies IT. Publications and Support IT. PublicationsPublication Description Intelligent Technologies IT. Qsnap Page Response network that gives new meaning to customer service Eaton’s Cutler-Hammer Aftermarket Services