| Rotronic AG | |
Bassersdorf, Switzerland | ||
Document code | Unit | |
|
|
|
HygroClip DI digital interface: instruction | Instruction Manual | |
manual |
| Document Type |
Document title | Page 7 of 24 | |
|
| |
|
|
|
6.Pin-out diagrams
Input 1, 2 and 3 (HygroLog NT2, NT3) - solder side of matching male connector
2
1
3
1: not used
2: power (DC+)
4 3: GND 4: DIO
5: not used
5
23
14
1:485
2:485 (+)
3:GND (see note)
4:DC + (see note)
Note: use pins 3 and 4 to power
7.Operation with the HW4 software
7.1HW4 software requirements
Note: a full description of HW4 is available in a separate manual. This document can be downloaded from our web site.
The following are the minimum values required to install and run HW4 on a computer. It is highly recommended to exceed these values.
●Processor: Pentium II, 450 MHz
●RAM: 128 MB
●Available hard disk space: 50 MB
●Monitor: SVGA, 1024 x 768, 256 colors
●Ports: one free serial (COM) port or one free USB port
© 2007; Rotronic AG |