|
| Rotronic AG |
| Bassersdorf, Switzerland | |
Document code | Unit | |
HygroClip DI digital interface: instruction | Instruction Manual | |
manual | Document Type | |
|
| Page 2 of 24 |
Document title |
| |
Contents: |
| |
1. | Overview | 3 |
2. | Models | 3 |
3. | Power supply | 4 |
4. | Probes | 4 |
5. | Connector identification | 6 |
6. | 7 | |
7. | Operation with the HW4 software | 7 |
7.1 | HW4 software requirements | 7 |
7.2 | HW4 Device Manager | 8 |
7.3 | Compliance with FDA 21CFR Part II and GAMP | 14 |
7.4 | Device protection | 14 |
7.5 | Probe adjustment | 17 |
8. | Baud rate compatibility requirements | 17 |
9. | Ethernet local area network | 18 |
10. | 18 | |
11. | Specifications | 20 |
12. | Accessories | 21 |
13. | Communications protocol | 21 |
14. | Electrical Installation Guidelines | 22 |
15. | Document releases | 24 |
About the version number:
This manual is valid for instruments with firmware version 1.0 (check using the ROTRONIC HW4 software, Device Manager). Changes in the last digit of the version number reflect minor changes in the internal software of the instrument that do not affect the manner in which the instrument should be operated.
IMPORTANT: operation of the HygroClip DI requires a PC with the ROTRONIC HW4 software version 1.2.2 or higher. Instructions for using the HW4 software are not included in this manual. These instructions are shipped separately on the software CD ROM.
© 2007; Rotronic AG |