CyberPower Systems CPS3000PIE user manual Troubleshooting, Problem, Possible Cause, Solution

						CPS3000PIE
Battery Icon Flash	Beep Once		Battery Missing- In Line		Turn the EPS off, check
				Mode Battery		battery wiring and
				Missing.		presence of battery
Fault Icon	1.	Rapid Beep	1.	Low Battery	1.	Recharge the
	2.	Recurring Beep		Output-Off		battery.
	3.	Long Beep		--Insufficient battery	2.	Inform service
				capacity.		agents.
			2.	Over Charge or AVR	3.	Check the EPS
				Error--In Line Mode,		output to see if
				battery is overcharged		there is a short
				or AVR is faulty.		circuit.
			3.	Short Output-Off --
				Output Short Circuit
				Protection
Can Not Start Up		None	1.	Line Input/Output	1.	Check Input/Output
				Error Output-Off --		connection.
				incorrect Input/Output	2.	Check the reason
				connection		for battery
			2.	Cold Start Battery		over-voltage.
				High Voltage
				Output-Off -- the
				battery voltage is too
				high during cold start.

TROUBLESHOOTING

Problem	Possible Cause	Solution
Full-time surge protection	Circuit breaker has tripped	Turn the EPS off and unplug at least
outlets stop providing	due to an overload.	one piece of equipment. Wait 10
power to equipment.		seconds, reset the circuit breaker by
Circuit breaker button is		depressing the button, and then turn
projecting from the side		the EPS on.
of the unit
The EPS will not turn on.	The on/off switch is	Turn the EPS off. Wait 10 seconds
	designed to prevent damage	and then turn the EPS on.
	by rapidly turning it off and
	on.
	Mechanical problem.	Contact Cyberpower Systems via
		phone at +31 (0) 40 2348170 or visit
		our website at
		www.cyberpowersystems.com

12