Mark Levinson N 320S owner manual Teach IR Menu, Rec.Out

Page 43

Setup Menu

Rec.Out

NONE, #1, #2, BOTH

3-8

Mark Levinson

(continued)Assigns record output connectors to the selected input. The rear panel offers two single-ended (RCA) stereo record output connectors that pass audio at fixed volume levels. When an input is assigned for the record output connectors, the input signal is sent to both the assigned main and record output connectors. The master volume, balance, and polarity controls do not affect record output levels.

Select the NONE setting to assign no record output connectors to the selected input. Select the #1 setting to assign the stereo record output connector labeled 1 to the selected input. Select the #2 setting to assign the stereo record output connector labeled 2 to the selected input. Select the BOTH setting to assign both record output connectors to the selected input.

CAUTION

IF THE ASSOCIATED COMPONENT OFFERS BOTH RECORD INPUT AND OUTPUT CONNECTORS, IT IS RECOMMENDED TO SET THE REC.OUT PARAMETER TO NONE TO PREVENT RECORD FEEDBACK LOOPS IN WHICH THE ASSOCIATED COMPONENT ATTEMPTS TO RECORD ITS OWN OUTPUT SIGNALS. THESE FEEDBACK LOOPS PRODUCE HIGH-LEVEL NOISE THAT MAY DAMAGE THE LOUDSPEAKERS AND/ OR OTHER ASSOCIATED COMPONENTS.

Note

If the associated component connected to the record output connectors is also connected to a separate ground (such as a VCR with a cable TV connection), it is recommended to set the Rec.Out parameter for all activated inputs to NONE unless a recording session is in progress. This helps prevent low-level electrical noise from degrading performance.

Teach IR Menu

Selecting Teach IR opens the menu shown in the top-left corner of the next page, which prompts the selection of the desired IR command. Selecting an IR command sends the associated infrared signal from the left side of the front panel display to a learning remote control, allowing Nº 320S IR commands to be sent from a learning remote control even if the Nº 320S remote control is not present.

Page 42 Page 44
Image 43
Page 42 Page 44
Contents Nº 320S Preamplifier This triangle, which appears on your component Important Safety InstructionsCustomer Support Table of Contents Index Troubleshooting & MaintenanceControls & Modes AppendixDocumentation Conventions Getting Started Special Design FeaturesGetting Started Mark Levinson Nº 320S HighlightsBalance control Installation ConsiderationsIr input connector RS-232 port Product Registration UnpackingQuantity PlacementTo replace the remote control batteries Remote Control BatteriesWarm-Up & Break-In Period Power RequirementsContinuous Operation Quick Start GuideNever Make or Break Connections to the Nº 320S To begin using the Nº 320SQuick Start Guide Basic Operation Power buttonFront Panel Overview Polarity LED Standby button & LEDSelect knob Front panel displaySetup button & LED Volume knobEnter button Balance button & LED Display intensity buttonMute button & LED Rear Panel Overview ~ac mains connectorStereo main output connectors Stereo input connectorsBasic Operation Slave in communication ports Stereo record output connectorsSerial number label Phono ground connectorTrigger output connector Ir input connectorMaking Link Connections LinkingNº 320S is compatible with Making Link Connections Table below correspond with the component listed All slave chainsLink communication port names differ among Mark Levinson Components. The Link communication port names usedTo create a slave chain that includes the Nº 320S Nº390S Nº360S Link ControlsPlayback DisplayIntensity StandbyOperation Considerations Remote Control OverviewIR transmitter Command OverviewStandby Setupenter Setup buttonSelect ± buttons Volume ± buttonsMono button Polarity buttonBalance button Display buttonNº 320S Navigating the Setup Menu Setup MenuEnter button Setup buttonSetup Menu To open the setup menuSet Inputs Menu Select knob ± buttons Volume knobDefault Possible Parameter Setting Settings Name Factory-Default, CustomTo shortcut to the Set Inputs menu for the selected input Set Inputs Menu ShortcutName Custom Names ListNo30, No30.5 UnusedActivates SSP surround sound processor mode, which RtoRTo customize the name of the selected input Character ListGain parameter should be set before the Offset parameter Nº 320S Setup MenuGain OffsetRec.Out Teach IR MenuCommand Description To teach Nº 320S IR commands to a learning remote control Trig Setup Menu ParametersMute MaxVolStandby Controls & ModesControls & Modes To set the sleep timerWhen the OFF 0% illumination level is selected Display IntensityBalance To adjust display intensityTo adjust main output signal polarity PolarityControls & Modes Mark Levinson Mono Playback To select the desired mono modeTo toggle between mono and stereo playback To use the L + R balance control + R Balance Control TipTo use L R mono playback to align phono cartridge azimuth Phono Alignment TipSSP Surround Sound Processor Mode To activate and use SSP mode Saving Data Troubleshooting 5Troubleshooting & MaintenanceNo Power No Remote Control Operation No IR Learning No Main Output No Record Output Audible Hum Troubleshooting & MaintenanceNº 320S To restore factory-default settings Restoring Factory-Default SettingsNº 320S Troubleshooting & Maintenance Care & MaintenanceDo not Apply Liquid Directly to the Nº 320S Specifications are subject to change without notice SpecificationsAppendix Input Overload Input Impedance Output Impedance Crosstalk Residual Noise Frequency Response WeightSetting Connectors AppendixFront View DimensionsTop View Mute Polarity MaxVol Intensity Trig Balance Mono Playback Installation WorksheetIndex Index Nº320S Reel-to-reel players Remote control Obtaining service, IBCPower consumption, Nº320S, A-1 Power requirements, Nº320S, 1-7 toWarm-up & break-in period, Nº320S, 1-7 to Troubleshooting, 5-1 to 5-3TUNER input name, 3-5tunersObtaining Service

N 320S specifications

The Mark Levinson N 320S is a standout in the field of high-performance audio, representing an exquisite blend of cutting-edge technology and timeless design. Known for its remarkable fidelity and expansive sound stage, this device appeals to audiophiles who demand nothing but the best from their sound systems.

One of the main features of the N 320S is its dual-mono architecture. This design ensures that both channels have separate power supplies, signal paths, and amplification stages, which minimizes crosstalk and enhances audio purity. The result is a stereo experience that is expansive and richly detailed, allowing listeners to appreciate the subtle nuances in their favorite music tracks.

The N 320S also incorporates advanced digital signal processing capabilities. With a high-resolution DAC (digital-to-analog converter), it supports various file formats, including top-tier high-resolution audio. This versatility means that whether listeners prefer streaming hi-fi music or playing from a local library, the N 320S can handle it all with ease, offering pristine sound quality.

Additionally, the inclusion of a proprietary Harman Logic 7 processing technology allows the N 320S to deliver an immersive surround sound experience from stereo sources. This capability transforms simple two-channel audio into an enveloping sound field, enhancing the listening experience for movies and concerts alike.

The build quality of the Mark Levinson N 320S further exemplifies its commitment to excellence. Constructed with premium materials and meticulous craftsmanship, it not only performs exceptionally but also looks stunning in any audio setup. The front panel features a sleek design with a large, easy-to-read display, and its intuitive controls ensure that users can navigate through settings effortlessly.

In terms of connectivity, the N 320S provides a multitude of input options, including analog and digital connections, as well as Bluetooth capabilities for wireless streaming. This wide range of inputs makes it highly versatile, allowing users to integrate it seamlessly into their existing audio systems.

Overall, the Mark Levinson N 320S is a testament to the brand's dedication to high-fidelity sound and innovative technology. With its impressive features and sophisticated design, it stands as a remarkable choice for those who seek an elite audio experience. Whether for music or cinema, the N 320S delivers in a way few others can, making it a prized addition to any audiophile's collection.
Top Page Image Contents