Mark Levinson 433 owner manual Power Button, Standby Button, Mark Levinson

Page 14

2. Power Button

Note:

14

Mark Levinson

2. Power Button

Powers the Nº433 on and off when the power cord is connected to the ~ac mains connector and an electrical outlet. When the Nº433 is powered on, pressing and releasing the power button disconnects power from the ~ac mains connector and powers the Nº433 off.

When the Nº433 is powered off, pressing and releasing the power button connects power to the ~ac mains connector and powers the Nº433 on. If the power save mode switch is set to on, the Nº433 enters sleep mode. If the power save mode switch is set to off, the Nº433 enters standby. See page 18 for more information on the power save mode switch.

The Nº433 must be powered on with the power button to respond to remote trigger commands.

3. Standby Button

Places the Nº433 into standby or sleep mode and takes the Nº433 out of standby or sleep mode. When the Nº433 is powered on, pressing and releasing the standby button places the Nº433 into standby or takes the Nº433 out of standby, allowing it to remain warmed-up to deliver optimal performance at all times.

Pressing and holding the standby button places the Nº433 into sleep mode. When the Nº433 is in sleep mode, pressing and releasing the standby button takes the Nº433 out of sleep mode. If the power save mode switch is set to on, the Nº433 powers on into sleep mode. If the power save mode switch is set to off, the Nº433 enters standby.

Image 14

Contents No433 Power Amplifier Important Safety Instructions operate the equipment FCC NoticeImportant Safety Instructions 2005 Harman Specialty Group. All rights reserved Table of Contents Unpacking Product RegistrationVentilation Installation ConsiderationsPlacement Mark Levinson Power Requirements Warm-up& Break-InPeriod2. Sleep Mode Operating States1. Off 3. StandbySpecial Design Features Massive Power Supply Balanced DesignMark Levinson Extensive ProtectionThese fault conditions include Front Panel 1. Indicator LEDMark Levinson 2. Power Button3. Standby Button 2. Loudspeaker Binding Posts Outputs Rear Panel1. Rear Panel Handles 3. Unbalanced Input 5. RS-232Communications Port Nº433 Power Amplifier4. Balanced Input 6. Communication PortsMark Levinson 7. trigger in and out connectors8. power save mode switch Danger 9. ~ac mains connectorLinking Making Link Connectionscommunication port specifications for other Constructing Link Communication CablesNº433 Power Amplifier tation for Link orComponent Creating a Slave ChainMark Levinson Requirements and ConnectionsTo create a slave chain that includes the Nº433 Nº433 Power AmplifierPower Amplifier No40 Media ConsoleMark Levinson Power Amplifier Link ControlsNº433 Power Amplifier Note the followingTroubleshooting DangerNº433 Power Amplifier Mark Levinson 8. The amplifier keeps powering off9. If all else fails Care & Maintenance Nº433 Power AmplifierSignal to Noise ratio Input impedance SpecificationsRated power output Frequency response Power consumption Mains voltageStandards to which Conformity is Declared Declaration of ConformityApplication of Council Directives ManufacturerMark Levinson Dimensionsstandby power 17.75 45.09 cmRack-Mounting Part No. 070-630694 Rev 1 09/05