Mark Levinson 433 Creating a Slave Chain, Mark Levinson, Component, Requirements and Connections

Page 22
Creating a Slave Chain

Note

Creating a Slave Chain

Note

22

Mark Levinson

Contact an authorized Mark Levinson dealer or Customer Service at www.marklevinson.com for additional assistance making Link connections.

Making Link connections creates a slave chain that facilitates communication among linked components, allowing them to share certain controls.

All slave chains:

•Must include compatible Mark Levinson components. The Nº433 is compatible with the components listed on the previous page. Refer to the appropriate documentation for Link compatibility information for other Mark Levinson components.

•Must include components that are connected in a certain order to prevent communication from prematurely terminating. Power amplifiers such as the Nº433 must be the last component in a slave chain.

The slave chains in this section include preamplifiers and power amplifiers. However, slave chains can also include digital audio processors and digital transports. Refer to the appropriate documentation for information about including these Mark Levinson components in a slave chain.

The table below indicates slave chain requirements for preamplifiers and power amplifiers.

Component

Requirements and Connections

 

 

Preamplifier

• No maximum number per slave chain.

(e.g., No320S or No326S)

• Connect eight-pin to six-pin Link cable from the

 

 

or slave out communication port on the

 

preamplifier to the

input communi-

 

cation port on the first power amplifier.

 

 

No32 Preamplifier

• Connect six-pin to six-pin Link cable from the

 

amp communication port on the No32 pream-

 

plifier to the

input port on the No433

 

power amplifier.

 

 

 

 

Page 21 Page 23
Image 22
Page 21 Page 23
Contents No433 Power Amplifier Important Safety Instructions Important Safety Instructions FCC Noticeoperate the equipment 2005 Harman Specialty Group. All rights reserved Table of Contents Unpacking Product RegistrationPlacement Installation ConsiderationsVentilation Mark Levinson Power Requirements Warm-up& Break-InPeriod2. Sleep Mode Operating States1. Off 3. StandbySpecial Design Features Massive Power Supply Balanced DesignThese fault conditions include Extensive ProtectionMark Levinson Front Panel 1. Indicator LED3. Standby Button 2. Power ButtonMark Levinson 1. Rear Panel Handles Rear Panel2. Loudspeaker Binding Posts Outputs 3. Unbalanced Input 5. RS-232Communications Port Nº433 Power Amplifier4. Balanced Input 6. Communication Ports8. power save mode switch 7. trigger in and out connectorsMark Levinson Danger 9. ~ac mains connectorLinking Making Link Connectionscommunication port specifications for other Constructing Link Communication CablesNº433 Power Amplifier tation for Link orComponent Creating a Slave ChainMark Levinson Requirements and ConnectionsTo create a slave chain that includes the Nº433 Nº433 Power AmplifierPower Amplifier No40 Media ConsoleMark Levinson Power Amplifier Link ControlsNº433 Power Amplifier Note the followingTroubleshooting DangerNº433 Power Amplifier 9. If all else fails 8. The amplifier keeps powering offMark Levinson Care & Maintenance Nº433 Power AmplifierSignal to Noise ratio Input impedance SpecificationsRated power output Frequency response Power consumption Mains voltageStandards to which Conformity is Declared Declaration of ConformityApplication of Council Directives ManufacturerMark Levinson Dimensionsstandby power 17.75 45.09 cmRack-Mounting Part No. 070-630694 Rev 1 09/05
Top Page Image Contents