Mark Levinson 433 owner manual Mark Levinson

Page 24

Manual background

24

Note

Mark Levinson

Refer to the table on the previous page and to the illustration below for additional assistance. Refer to pages 20-21 for specific cable uses and instructions.

3.When Link connections have been made, power on linked components ONE AT A TIME in the order specified below. Allow each component to complete its initialization sequence before proceeding to the next component.

A.Digital Transports

B.Digital Audio Processors

C.Preamplifier

D.Power Amplifiers (begin with the first power amplifier in the slave chain)

At this point, the front panel standby LEDs on all linked compo- nents should be blinking in unison.

Linked components must be powered on ONE AT A TIME in the specific order listed in step 3 (above) to ensure proper functioning of Link controls. DO NOT use a power strip switch to power on several components at once. When power is supplied to a power strip, connected components that do not include a power button will automatically power on.

4.Take the linked preamplifier out of standby.

•All linked power amplifiers should come out of standby as well. If this does not occur, repeat steps 3 and 4. If problems persist, contact an authorized Mark Levinson dealer or Customer Service at www.marklevinson.com.

Image 24

Contents No433 Power Amplifier Important Safety Instructions FCC Notice Important Safety Instructionsoperate the equipment 2005 Harman Specialty Group. All rights reserved Table of Contents Unpacking Product RegistrationInstallation Considerations PlacementVentilation Mark Levinson Power Requirements Warm-up& Break-InPeriodOperating States 1. Off2. Sleep Mode 3. StandbySpecial Design Features Massive Power Supply Balanced DesignExtensive Protection These fault conditions includeMark Levinson Front Panel 1. Indicator LED2. Power Button 3. Standby ButtonMark Levinson Rear Panel 1. Rear Panel Handles2. Loudspeaker Binding Posts Outputs 3. Unbalanced Input Nº433 Power Amplifier 4. Balanced Input5. RS-232Communications Port 6. Communication Ports7. trigger in and out connectors 8. power save mode switchMark Levinson Danger 9. ~ac mains connectorLinking Making Link ConnectionsConstructing Link Communication Cables Nº433 Power Amplifiercommunication port specifications for other tation for Link orCreating a Slave Chain Mark LevinsonComponent Requirements and ConnectionsNº433 Power Amplifier Power AmplifierTo create a slave chain that includes the Nº433 No40 Media ConsoleMark Levinson Link Controls Nº433 Power AmplifierPower Amplifier Note the followingTroubleshooting DangerNº433 Power Amplifier 8. The amplifier keeps powering off 9. If all else failsMark Levinson Care & Maintenance Nº433 Power AmplifierSpecifications Rated power output Frequency responseSignal to Noise ratio Input impedance Power consumption Mains voltageDeclaration of Conformity Application of Council DirectivesStandards to which Conformity is Declared ManufacturerDimensions standby powerMark Levinson 17.75 45.09 cmRack-Mounting Part No. 070-630694 Rev 1 09/05